Abstract:Due to the distinctive characteristic of massive flow rates, double-suction centrifugal pump has been extensively applied in lots of perspectives, such as drainage, irrigation, transportation projects and other hydraulic engineering realms. Nevertheless, the significance of the pressure fluctuation inside the double-suction centrifugal pump, which is getting more and more prominent under the soaring demands for low noise and comfortable living environment, could not be underestimated. Consequently, how to reduce the pressure fluctuation as far as possible and enhance the running stability of the pump is always the research hotspot. In this study, the double-suction centrifugal impeller with abominable vibration performance is redesigned to improve the internal flow and reduce the flow-induced noise. What’s addition, the two redesigned impellers wearing splitter blades were compared in staggered arrangement with different angles for the purpose of ulteriorly decreasing the pressure fluctuation. On the basis of Realizable k-ε model and SIMPLEC algorithm, the unsteady Reynolds-averaged Navier-Stokes equations (URANS) were resolved by means of CFD simulation and the flow performance and the vibration performance were validated with the experiments. The results illustrate that the redesigned impeller with multi-blade could raise the hydraulic performance and reduce the pressure fluctuation inside the pump. When the impeller of each side was laid with the staggered angle of 12 degrees, the pressure distribution tended to be more uniform and the pressure fluctuation was well ameliorated. Through the pressure fluctuation analysis in time domain and frequency domain, the pressure change inside the pumps could be evaluated quantitatively and accurately, hence different pumps could be contrasted in detail. The consequences of this paper could provide reference for pressure fluctuation reduction and vibration performance reinforcement of double-suction centrifugal pumps as well as other vane pumps.

Improvement on Acoustic Performance of the Accumulator of Double-Cylinder Rotary Compressors

Amelioration of Acoustic Performance of Two-cylinder Compressors by Using Single-pipe Suction Accumulator

Analysis and Suppression of Gas Flow Noise from the Accumulator of Rotary Compressor

Reduction of Radiated Noise from Rotary Compressors by Acoustic Interference Effects

Prediction and Control Research for Noise Radiation of a Rotary Compressor Accumulator

Investigation on the influence of working pressure on the performance of the thermoacoustically driven RC load

Investigation of Suction Pressure Pulsation Prediction of Rotary Compressor with Total Variation Diminishing Scheme and One-Dimensional Accumulator Model

Analysis of Dynamic Performance for New Double-bladder Accumulator

Study On Acoustic Performance Of A Water Muffler For Gear Pump

Simulation Research on Distribution Method of Axial Piston Pump Utilizing Pressure Equalization Mechanism

STUDY ON THE REDUCTION OF PRESSURE FLUCTUATION FOR A DOUBLE-SUCTION CENTRIFUGAL PUMP WITH STAGGERED BLADES

Acoustic Impedance Characteristics of Linear Compressors

Numerical and Experimental Studies on Housing Optimization for Noise Reduction of an Axial Piston Pump

VIBRATION-ACOUSTICS STUDY OF R410A ROTARY COMPRESSORS

Investigation on the Pressure Pulsation in the Discharge Muffler of Rotary Compressors

Experimental studies of the vibro-acoustic characteristics of an axial piston pump under run-up and steady-state operating conditions

Study on Attenuation of Fluid-Borne Pulsation Using Accumulator

The Theoretical and Experimental Research of a Novel Rotary Cylinder Compressor

Vibration and pressure pulsation elimination in a reciprocating compressor suction system using an acoustic filter

Performance Research and Optimization of Sound Insulation Hood of Air Compressor Unit

Optimizing Accumulator Performance in Hydraulic Systems through Support Vector Regression and Rotational Factors