Abstract:Abstract Abnormal discontinuous low-frequency noise occurs in the outdoor unit when the air conditioner is operating at 86~96 Hz. This noise has the characteristics of low frequency, strong penetration, long transmission distance, and poor sound quality, which can cause serious noise pollution. In order to reduce the low-frequency noise of the outdoor unit of the air conditioner, the discontinuous noise frequency is first located by testing the time-domain and frequency-domain maps of the noise. It is then compared with the frequency of fan rotation noise and structural radiation noise. It is found that the discontinuous noise is caused by the coupling of fan rotation noise and structural radiation noise. It is found that low-frequency noise improvement is significant when the frequency difference between two noise peaks is greater than 8 Hz or when a single noise peak is less than 25 dB(A) by studying the methods of frequency modulation and amplitude modulation of noise peaks. By adjusting the fan speed from 930 rpm to 940 rpm, the problem of 94 Hz noise is solved. Then, through testing the natural frequencies of the pipe and shell, it is found that the natural frequencies of the pipe are close to the excitation frequencies. The structural radiation noise is mainly caused by the pipe. Modal analysis is conducted on the pipe. When the normal boundary with the condenser and the normal boundary with the valve of the pipe is constrained by springs, the simulated values are closer to the measured values. Finally, structural optimization design is carried out on the pipe. When the U-tube of the exhaust pipe is shortened by 30 mm, a 30 g mass block is added to the cold inlet pipe, and a 97 g mass block is added to the lower part of the valve pipe of the suction pipe. The discontinuous noise of the optimized prototype is significantly improved.

Reduction of Radiated Noise from Rotary Compressors by Acoustic Interference Effects

Numerical Analysis of Noise Radiation from Refrigerator Compressor Shell

Numerical Analysis Of Noise Radiation Of Compressor Shell Considering Lubrication Oil

Numerical analysis of the influence of lubrication oil on noise radiation of compressor shell

Noise Analysis and Control of Reciprocating Refrigerators Compressor

Investigation on the influence of working pressure on the performance of the thermoacoustically driven RC load

Acoustic Impedance Characteristics of Linear Compressors

Noise control of a twin-screw refrigeration compressor

Numerical analysis of aerodynamic noise in a high parameter pressure reducing valve

The Effects of the Orifice Plate Structure on the Aerodynamic Noise in the High Parameter Pressure Reducing Valve

Numerical Investigation into Acoustics Characteristics towards Pressure Reducing Valve with High Ratio of Reduced Pressure

Control of noise generated from centrifugal refrigeration compressor

Experimental Study Of Noise Characteristics Of Submerged Exhaust Process

Numerical and Experimental Studies on Housing Optimization for Noise Reduction of an Axial Piston Pump

An Investigation of the Acoustic Enclosure of an Air Conditioning Compressor Using Response Surface Analysis and Topological Rigidity Optimization

Numerical Simulation of Flow-Induced Noise in High Pressure Reducing Valve

Low-Frequency Discontinuous Noise Diagnosis and Reduction of Air Conditioner Outdoor Unit

Acoustic power measurement of linear compressors

Noise control of a two-stage screw refrigeration compressor

Simulation and experimental research on aerodynamic noise of gas turbine 1.5-stage axial compressor

Experimental Study on Noise Reduction Effect of a Muffler Inserted in Liquid Transporting Pipeline