Abstract:Ductile iron pipes are widely used in pipe manufacturing for water and sewage transmission and distribution. In pipeline standards such as EN545, the pipe material is assumed isotropic and its mechanical properties are determined by tensile testing of round bars extracted along the longitudinal direction. This study experimentally examined the mechanical properties of centrifugal casting ductile iron pipes, focusing on the effects of sampling orientation, location, preparation, and test methodology. A ring hoop tension test (RHTT) was designed to evaluate circumferential properties. Force analysis of RHTT was performed and theoretical equation was derived to quantify the friction coefficient that existed between the coupon specimen and the loading fixture. A numerical study was conducted to further validate the effectiveness of the proposed theory. The test results indicated that the pipe mechanical property was inhomogeneous across the wall thickness, being inferior in the internal section and superior in the middle and external sections. This inferior layer would develop crack first and lead to subsequent outward propagation. This phenomenon led to a substantial degradation in the overall mechanical performance of the entire specimens, in comparison to the material in the middle portion. The material exhibited better performance in the circumferential direction compared to the longitudinal direction in terms of its mechanical properties, such as tensile strength and ductility. Flattened specimens showed enhanced strength and reduced ductility compared to the base pipe material. Fractographic and metallographic analyses revealed the existence of casting defects of porosity and agglomerated graphite in the internal section, which were the primary cause of material inhomogeneity. The round bars suggested per EN545 tended to overestimate the actual mechanical behaviour of ductile iron pipes, and may not be a true representation of the finished product of pipes. Flattened specimens as per ASTM E8/E8M were not recommended for ductile iron pipe material assessment, as the flattening process altered the stress–strain characteristics significantly.

Research on Inhomogeneity of X65 Steel Pipes Used for Submarine Pipeline with Heavy Wall Thickness

Effect of through-thickness microstructure inhomogeneity on mechanical properties and strain hardening behavior in heavy-wall X70 pipeline steels

Study on TRIP Effect of X65 Pipeline Steel

Microstructure and mechanical properties of X90 high strength pipeline steel

Load Condition and Performance Requirement Analysis of Submarine Linepipe

Effect of Microstructure on Mechanical Properties of X65MS Welded Pipe Joint

Study on performance degradation of main steam pipe of X20CrMoV12.1 steel for long-term service

Inhomogeneity in mechanical properties of ductile iron pipes: A comprehensive analysis

Study on Fracture Behavior and Toughening Mechanisms of Ultra-High-Strength Pipeline Steel

Research of Micro-Alloyed Microstructure and Composition in X80 Pipeline Steel for High Heat Input Welding

Inhomogeneous Strain Behaviors of the High Strength Pipeline Girth Weld under Longitudinal Loading

Corrosion Behavior of X65 Pipeline Steel: Comparison of Wet–dry Cycle and Full Immersion

Analysis on Ultimate Bearing Capacity of Deepwater Submarine Pipe

Microstructure Characterization and Strengthening Mechanism Analysis of X100 Pipeline Steel

Experimental Research and Manufacturing Technology of Heavy Gauge WPHY-80 Pipe Fitting Plate with Uniform Microstructure

Microstructural Evolution and Mechanical Properties of Reeled X65 Pipeline Steel during Cyclic Plastic Deformation and Natural Aging

Fracture behavior analysis of X80 pipelines welded joints with unequal wall thickness

Changes in microstructure and properties of weld heat-affected zone of high-strength low-alloy steel

Fracture driving forces of cracked girth welds with mechanical heterogeneity for X80 pipes

Influence of Thermal Aging on Microstructure and Mechanical Behavior of X100 High Deformability Line Pipe

Studying the Microstructural Evolution in a Hot-Rolled Thick Gauge Microalloyed Line Pipe Steel