Copper Nanoparticle/Graphene Oxide/Single Wall Carbon Nanotube Hybrid Materials As Electrochemical Sensing Platform for Nonenzymatic Glucose Detection
Taotao Yang,Jingkun Xu,Limin Lu,Xiaofei Zhu,Yansha Gao,Huakun Xing,Yongfang Yu,Wanchuan Ding,Zhen Liu
DOI: https://doi.org/10.1016/j.jelechem.2015.12.015
IF: 4.598
2016-01-01
Journal of Electroanalytical Chemistry
Abstract:Cu nanoparticle/graphene oxide/single walled carbon nanotube (CuNP/GO/SWCNT) composites were prepared by a facile electrodeposition method and used for constructing nonenzymatic glucose sensor. Scanning electron microscopy (SEM) and Raman spectroscopy were employed to characterize the morphology and structures of the samples. The electrocatalytic performance of CuNP/GO/SWCNT composites towards glucose oxidation was studied by cyclic voltammetry (CV) and current–time measurements. Electrochemical results indicated that CuNP/GO/SWCNT electrode exhibited a higher electrocatalytic activity towards the oxidation of glucose than CuNP, CuNP/GO and CuNP/SWCNT electrodes. This was because the GO/SWCNT composite as substrate material not only possessed excellent conductivity, but also provided large surface area for the high loading of the CuNPs. Meanwhile, the good dispersibility, independent and multi-layer structure of CuNP, could enhance the charge-transport properties, and afford more active sites for the catalytic oxidation of glucose. Under the optimized conditions, the sensor showed a high sensitivity of up to 930.07μAmM−1cm−2, with a wide linear range of 1μM to 4.538mM and a low detection limit of 0.34μM (S/N=3). It also exhibited excellent stability, reproducibility, selectivity, and reliable measurement in real human blood samples. All of these excellent properties made the CuNP/GO/SWCNT composite material promising for the development of effective nonenzymatic glucose sensors.