Abstract:Superheated droplets vaporized in a vacuum or vapor chamber was studied using smoothed particle hydrodynamics method.The two-phase fluids of vapor and liquid with a diffused interface were modeled by Navier-Stokes-Korteweg equations,with the van der Waals equation of state.The liquid-vapor separation was processed with different initial temperature and density.Simulation was firstly validated by the proper equilibrium states with analytical data from the binodal line of Maxwell construction,as well as the droplet surface tension compared with experimental and other groups'numerical data in a good agreement.Droplet morphology,density,temperature and entropy increment were then carefully examined during the dynamic process from evaporation to boiling.Four phase transitions patterns were concluded,namely from surface evaporation,internal bubble,fragment and explosion,to flash boiling with increasing equivalent superheat degree that is defined by the non-dimensional superheat temperature over surface tension.Results showed that droplet temperature and density decreased slightly at surface evaporation when equivalent superheat degree was lower than 1/3.Above this criterion,the internal bubble could be sustained.Growth of new liquid nucleates and connected secondary liquid ring were calculated by domain growth theory.We found that droplet continuous to expand at high superheat but withdrawn at equivalent superheat degree equal to or lower than 0.52.At equivalent superheat degree higher than 1,the growth and expansion of droplet resulted in liquid fragment and explosion to many small secondary droplets.Mean mass and diameter of these droplets were found to have power-law dependency on the expansion rate.Finally,fast flash boiling occurred at equivalent superheat degree higher than 3.The vapor pressure in the chamber showed a negative linear correlation between the overpressure and the atmospheric pressure.We also found out that comparing to increase the pressure value,dense gas had better efficiency on retarding the propagation of shock wave.

Performance of a new vapor–liquid–solid three-phase circulating fluidized bed evaporator

FLOW BOILING HEAT TRANSFER IN A NEW VAPOR-LIQUID-SOLID THREE-PHASE CIRCULATING FLUIDIZED BED EVAPORATOR

Experimental Study on High-efficient Evaporator in Large Quick-freeze Equipment

Experimental study on high efficiency evaporator in a large quick-freeze equipment

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Study of the Natural Circulation Flow Boiling Heat Transfer Based On Partially Superhydrophilic Surface Modification

Heat transfer performance of a vapor–liquid–solid three-phase circulating fluidized bed evaporation system with different concentrations of Na2SO4 solutions

Effect of particle collision behavior on heat transfer performance in a down-flow circulating fluidized bed evaporator

Heat Transfer and Pressure Drop of Vapor-Liquid Solid Three-Phase Boiling Flow of Binary Mixtures

Droplet Evaporation to Boiling in Van Der Waals Fluid

Performance of Falling Film Evaporator in Vertical Tube Combined with Vapor-Lift Effect:Hydrodynamic Characteristics

Effectiveness of actively adjusting vapour-liquid in the evaporator for heat transfer enhancement

Experimental Study on the Heat Transfer Performance of Pump-assisted Capillary Phase-change Loop

Modeling and Simulation of a Falling Film Evaporator for a Water Vapor Heat Pump System

Performance Of A Three-Phase Fluidized Bed As A Reactive Distillation Device

Important Analysis of Liquid Vaporization Modeling Scheme in Computational Fluid Dynamics Modeling of Gas–Liquid–Solid Polyethylene Fluidized Bed Reactors

Establishment of the falling film evaporation model and correlation of the overall heat transfer coefficient

Thermodynamic performance study on the novel efficient flow pattern global construction evaporator

Experimental and Numerical Investigation on Heat Transfer Performance of Water Evaporators with Different Channels and Fin Structures in a Sub-Atmosphere Environment

Thermal-hydraulic Calculation and Analysis on Evaporator System of a 660 MWe Ultra-Supercritical CFB Boiler

Experimental study on heat transfer performance of high efficient tube for falling film evaporator