Abstract:CFD methodology for subcooled flow boiling is significantly affected by the heat flux partitioning model, which plays a crucial role in predicting the mass source term generated by wall boiling of the liquid phase. Although numerous models have been proposed, most research efforts have focused on the spatial dimensions of boiling heat transfer mechanisms, neglecting the temporal aspect. This study presents a heat flux partitioning model for subcooled flow boiling that considers both temporal and spatial dimensions. The model accounts for the contribution of heat flux from the superheated liquid layer during the bubble growth stage, liquid convection during the bubble wait stage within the bubble influence area in the temporal dimension, and heat flux from the overlapping area of bubble influence in the spatial dimension. An approach was developed to determine the bubble influence area by considering the bubble interaction based on the stochastic nature of nucleation sites on the heated wall, verified by the Monte Carlo method. The bubble dynamics parameters were experimentally derived to reduce the uncertainty associated with the boiling sub-models on the calculation. A comparative analysis of boiling curves and wall heat flux partitioning was conducted between the present model and the RPI model under various flow conditions. The results indicate that both models could reasonably predict the boiling curve. However, the RPI model tends to over-predict the proportion of evaporative heat flux, which is considered a weakness. Based on physical principles, the present model accurately captures the fundamental trend of wall heat flux partitioning. This research enhances the understanding of subcooled flow boiling and increases confidence in multiphase CFD methodology predictions.

A study on laminar film boiling of liquid along isothermal vertical plates in a pool with consideration of variable thermophysical properties

Experiment for influence of boiling surface on critical heat flux in liquid nitrogen pool boiling

Subcooled Pool Film Boiling Heat Transfer from Spheres with Superhydrophobic Surfaces: an Experimental Study

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Film Boiling in Laminar Boundary-Layer Flow along a Horizontal Plate Surface

Multiphase SPH Modeling of Water Boiling on Hydrophilic and Hydrophobic Surfaces

Study of boiling heat transfer on the wall with an improved hybrid lattice Boltzmann model

Numerical Analysis of Saturated Film Boiling from a Heated Plate Facing Downwards (The Case of Constant Vapor Film Thickness Specified at the Edge as a Boundary Condition)

Regulation of Gas-Liquid Stratified Flow Boiling Dynamic Instabilities in Horizontal Tube: Effects of Heat Load Distribution and Wall Thermal Capacity

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

Numerical Study on Bubble Behaviour and Heat Transfer Characteristics of Subcooled Pool Boiling Based on Non-Empirical Boiling and Condensation Model

Analyses of Bubble Dynamics in Subcooled Boiling Flow Using Euler-Lagrange Method

Numerical study of a hybrid thermal lattice Boltzmann method for pool boiling heat transfer on a modeled hydrophilic metal foam surface

Lattice Boltzmann simulations of the pool boiling curves above horizontal heaters with homogenous and heterogeneous wettability

Model for Distribution of Heated Falling Liquid Film on Vertical Solid Planar Surface

Study on the Temperature Distribution of Heated Falling Liquid Films

Numerical Study of Heat Transfer on Flow Boiling in Vertical Tube by LB Method Simulation

An Investigation of Falling Liquid Films on A Vertical Heated/Cooled Plate

Pool boiling on vertical and horizontal heated plates with a dielectric fluid: Influence of vertical canal width

Film Boiling Heat Transfer for Liquid Flowing with High Velocity

Study on Shrinkage Characteristics of Heated Falling Liquid Films