Abstract:Excavation behaviours not only destroy the balance of original stress in rock mass but lead to the redistribution of initial stress, resulting in rock mass in a new stress environment. The static stress in rock mass has the characteristics of dynamic change. For the purpose of investigating the effect of increasing static stress on attenuation mechanism and energy dissipation of stress wave in sandstone under the overall deformation condition, small disturbance experiments on sandstone bar are carried out with a modified split-Hopkinson pressure bar test system. The stress waveform, p wave velocity, temporal and spatial attenuation of amplitude, and energy dissipation are studied under various static stresses. Results show that stress waveforms at different locations are approximately the same, those at the same locations vary greatly, and the tensile waves that appeared at the tails of stress waves are larger with increasing static stress. With increasing static stress, p wave velocity experiences a dramatic increase, then develops gently, and finally a sharp decrease; the stress demarcation points are σs/σc = 30% and σs/σc = 55%, respectively. P wave velocity can be predicted by a quadratic equation when σs/σc > 63.69%. The relation between longitudinal wave velocity and static stress can be described by a quadratic function. Stress wave amplitudes decrease exponentially with increasing distance and time. Values of temporal spatial response intensity (RI) and spatial RI are approximately equal and present the same development tendency of nonlinear and linear stages due to the same dimensions. Values of temporal attenuation characteristic (AC) and spatial AC are differed by 2 or 3 orders of magnitude although they present the same development tendencies. Ratios of RI and AC can indicate the sensitivity of temporal and spatial attenuation to different static stresses. Full-wave energy declines in an exponential function with increasing static stress and decays as a logarithmic function with increasing distance. Widespread attenuation characteristics like these should provide a theoretical basis for rock mass stability analysis.

Stress Wave Propagation Characteristics in a Bent Hopkinson Bar

Experimental Study on Stress Wave Propagation in Ultra High Toughness Cementitious Composites

Value of Penalty Factor During Simulation Stress Wave

An electromagnetic Hopkinson bar for low wave impedance material and complex stress paths loading tests

A novel Hopkinson tension bar system for testing polymers under intermediate strain rate and large deformation

Ultrasonic Measurement of Stress Considering Strain Effect

A split Hopkinson bar technique for low-impedance materials

Experimental Technique of High Strain-Rate Tension Based on Hopkinson Bar

Experimental study on stress wave attenuation and energy dissipation of sandstone under full deformation condition

THE EFFECT OF STRESS HETEROGENEOUS ON TEST DATA OF CONCRETE USING SHPB

Numerical Simulation of Shpb Experiment and Analysis on Stress Wave

Experimental and Numerical Analyses of the Rational Loading Waveform in SHPB Test for Rock Materials

Hopkinson Bar Loaded Fracture Experimental Technique: A Critical Review of Dynamic Fracture Toughness Tests

Hopkinson bar pulse smoothing

Further numerical investigation on concrete dynamic behaviors with considering stress non-equilibrium in SHPB test based on the waveform features

Using Stress Wave Based Technology for Wood Material Nondestructive Testing

Radial Inertia Effect of Ultra-Soft Materials from Hopkinson Bar and Solution Methodologies

LOADING CONDITION FOR SPECIMEN DEFORMATION AT CONSTANT STRAIN RATE IN SHPB TEST OF ROCKS

Hopkinson bar experiments as a method to determine impact properties of brittle and ductile materials

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

A new method for the separation of waves. Application to the SHPB technique for an unlimited duration of measurement