Abstract:The specimen strain rate in the split Hopkinson bar (SHB) test has been formulated based on a one-dimensional assumption. The strain rate is found to be controlled by the stress and strain of the deforming specimen, geometry (the length and diameter) of specimen, impedance of bar, and impact velocity. The specimen strain rate evolves as a result of the competition between the rate-increasing and rate-decreasing factors. Unless the two factors are balanced, the specimen strain rate generally varies (decreases or increases) with strain (specimen deformation), which is the physical origin of the varying nature of the specimen strain rate in the SHB test. According to the formulated strain rate equation, the curves of stress–strain and strain rate–strain are mutually correlated. Based on the correlation of these curves, the strain rate equation is verified through a numerical simulation and experiment. The formulated equation can be used as a tool for verifying the measured strain rate–strain curve simultaneously with the measured stress–strain curve. A practical method for predicting the specimen strain rate before carrying out the SHB test has also been presented. The method simultaneously solves the formulated strain rate equation and a reasonably estimated constitutive equation of specimen to generate the anticipated curves of strain rate–strain and stress–strain in the SHB test. An Excel® program to solve the two equations is provided. The strain rate equation also indicates that the increase in specimen stress during deformation (e.g., work hardening) plays a role in decreasing the slope of the strain rate–strain curve in the plastic regime. However, according to the strain rate equation, the slope of the strain rate–strain curve in the plastic deformation regime can be tailored by controlling the specimen diameter. Two practical methods for determining the specimen diameter to achieve a nearly constant strain rate are presented.

LOADING CONDITION FOR SPECIMEN DEFORMATION AT CONSTANT STRAIN RATE IN SHPB TEST OF ROCKS

Obtaining Constitutive Relationship for Rate-Dependent Rock in SHPB Tests

Numerical Simulation of the Rock SHPB Test with a Special Shape Striker Based on the Discrete Element Method

A Method for Testing Dynamic Tensile Strength and Elastic Modulus of Rock Materials Using SHPB

Numerical Investigation on the Necessity of a Constant Strain Rate Condition According to Material’s Dynamic Response Behavior in the SHPB Test

Theoretical Analysis of Stress Equilibrium of Linear Hardening Plastic Specimen During SHPB Tests

Dynamic Response of Rock-like Materials Based on SHPB Pulse Waveform Characteristics

Pulse Design of Constant Strain Rate Loading in SHPB Based on Pulse Shaping Technique

Dynamic Brazilian Test of Rock Under Intermediate Strain Rate: Pendulum Hammer-Driven SHPB Test and Numerical Simulation

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

Experimental and Numerical Analyses of the Rational Loading Waveform in SHPB Test for Rock Materials

Experimental and numerical investigation of crack propagation and dynamic properties of rock in SHPB indirect tension test

Experimental and Numerical Study of Fracture Behavior of Rock-Like Material Specimens with Single Pre-Set Joint under Dynamic Loading

Dynamic behavior of rock during its post failure stage in SHPB tests

Evolution of specimen strain rate in split Hopkinson bar test

Material behaviour characterisation using SHPB techniques, tests and simulations

A modified method for estimating the stress state of granular materials in the passive confined pressure SHPB tests

Dynamic Response and Failure Mechanism of Brittle Rocks Under Combined Compression-Shear Loading Experiments

Correlation between the accuracy of a SHPB test and the stress uniformity based on numerical experiments

NUMERICAL ANALYSIS OF EFFECT OF STRESS IMPULSE ON TESTING RESULT FOR CCCD-SHPB DYNAMIC FRACTURE TEST SYSTEM