Abstract:This study presents an adaptive algorithm for distance relays. In this algorithm, the network connected to the transmission line terminals are modelled using an equivalent circuit, and the impedances of this equivalent circuit are estimated. By employing this algorithm, relay errors (over/under reach) caused by changes in network structure, the presence of fault resistance, and injected current from the remote end of the transmission line are eliminated. As a result, the relay accurately determines fault location and fault resistance, enhancing the performance of its Zone1 and Zone2 functions. Faults in power systems occur for various reasons, such as aging or natural disasters. Detecting, locating, and promptly clearing these faults is crucial for maintaining the safety and reliability of transmission lines (TLs). Distance relays (DRs), which protect TLs, detect faults, estimate their location, and send the required commands. However, these relays may experience mis‐detection due to manipulated impedance arising from both internal and external factors. These factors include measurement device errors, network topology changes, the presence of fault resistance (FR), and injected currents from remote line terminals. To address this challenge, an innovative adaptive protection scheme that considers FR, changes in network topology, and injected current from the opposite end of the line is proposed. By estimating the equivalent circuit impedances (ECIs) of the network connected to the terminal of the TL, this protection scheme utilizes impedance estimation techniques at the line terminals and offline network information. Simulation studies (tested on the IEEE 39‐bus standard network) show that the proposed scheme accurately estimates fault location (FL) and FR with high precision. The simulation results demonstrate its effectiveness in improving the performance of conventional distance protection relays in both the first and second protection zones (Zone1 and Zone2 ).

Research on the Characteristics of Distance Element Based on the Power-frequency Voltage and Current Variation

New Type Adaptive Distance Relay with Improved Performance

Research on HV Line Protection Relay Based on Characteristic of Main Transient Frequencies

Error Analysis of Distance Relay Protection in Phase-to-Phase Short Circuit Fault

Fast distance protection based on real-time estimation of transient main frequency

Distance Protection That Insensitive to Power Swing

Infulence of Current Transformer Saturation on the Distance Protection

NOISE EVALUATION BASED ADAPTIVE FAST DISTANCE RELAY PROTECTION

Performance analysis of multiphase compensated distance relay in single-phase-to-ground fault with power swing

Some discussion on the fault component distance protection

A fault-component based adaptive distance protection scheme

Adaptive Distance Relay for Preventing Error Action of Reactive Fault

Distance protection for HVDC transmission lines considering frequency-dependent parameters

The Influence of Fixed Series Capacitor on Distance Protection Using Relay Models

Distance Protection Principle for Series Compensated Lines Based on the Impedance Angle of the Compensated Point

A Compensation Algorithm Based Distance Protection Considering Frequency-dependent Parameters

Principle and property research of the energy directional protection

A novel distance protection algorithm for long-distance transmission lines

An adaptive distance protection scheme considering fault resistance, injected current, and structural changes in the power system

Distance Protection Based on Frequency-domain Compensation Algorithm

A Novel Distance Protection Algorithm for the Phase-Ground Fault