Abstract:Calcium looping cycle for post-combustion CO2 capture has gained increasing attention worldwide. However, CaO-based sorbents derived from natural sources for calcium looping cycle experience rapid loss of capacity during high-temperature cyclic carbonation/calcination reactions. Synthesizing sintering-resistant CaO-based sorbents by adding a support material has been extensively studied as an effective method of combating the problem. The support material in the synthetic sorbents plays an important role in retaining the capacity, and various support materials have been tested in the literature. In practical reactors, sulfur is present and it has been reported that sulfation of sorbents will also reduce the CO2 capture capacity. However, thus far, it is not clear whether/how support material would affect sulfation of sorbents and, thus, CO2 capture. In this paper, four different support materials, such as Ca2MnO4, La2O3, Ca12Al14O33, and MgO, were studied. The cyclic CO2 capture performance of the synthetic sorbents made from CaO and the support materials were investigated in detail, in the presence of SO2 and steam. The results showed that a mass ratio of 20-25% support material would be optimum for synthesizing sorbents with high cyclic CO2 capture capacity, and Ca12Al14O33 and MgO seem to be more effective than Ca2MnO4 and La2O3. The 80:20 wt % CaO/MgO synthetic sorbent achieved the highest CO2 capture capacity under ideal conditions over 100 cycles. However, the CaO/MgO sorbent had a strong affinity to SO2 capture during cyclic reactions, especially in the presence of steam. Under realistic conditions (i.e., both SO2 and steam are present during carbonation), the CaO/MgO sorbent showed the highest cumulative SO2 capture capacity, whereas the CaO/Ca12Al14O33 sorbent obtained the highest CO2 capture capacity after 10 cycles. The smaller average crystallite size of MgO in the sorbent was responsible for the strong SO2 affinity of the CaO/MgO sorbent as well as its stable cyclic CO2 capture abilities under ideal conditions.

Cyclic carbonation characteristics of calcium-sorbents modified by acetic acid solution

Calcination–carbonation Durability of Nano CaCO3 Doped with Li2SO4

Optimization of Calcium Carbide Residue Utilization for Producing High‐quality Calcium Carbonate

Study on CO2 Absorption-Mineralization Characteristics of Mixed Amine Solution Coupled with CaO and Key Influencing Factors in Mineralization Process

Experimental research and modeling of multiple carbonation/calcination cycle of Ca-based CO2 sorbents

Effect of Preparation Temperature on Cyclic CO2 Capture and Multiple Carbonation−Calcination Cycles for a New Ca-Based CO2 Sorbent

Experiment of CO_2 Capture Based on Ca-based Sorbents Cyclic Calcination/carbonation Reaction

Modeling of Carbonation Reaction for CaO-based Limestone with CO2 in Multitudinous Calcination-Carbonation Cycles

Enhanced cyclic stability of CO 2 adsorption capacity of CaO-based sorbents using La 2 O 3 or Ca 12 Al 14 O 33 as additives

CYCLIC REACTION CHARACTERS OF CA-BASED CO2 ABSORBENTS

Synthesis and Performance of a Nano Synthetic Ca-based Sorbent for High Temperature CO_2 Capture

Studies on CO2 uptake by CaO/Ca3Al2O6 sorbent in calcium looping cycles

Development of CaO-based Sorbent Doped with Mineral Rejects–bauxite-Tailings in Cyclic CO2 Capture

Morphological Changes of Pure Micro‐ and Nano‐Sized CaCO3 during a Calcium Looping Cycle for CO2 Capture

Experiment and Modeling of Co2 Capture from Flue Gases at High Temperature in A Fluidized Bed Reactor with Ca-Based Sorbents

Effect of Support Material on Carbonation and Sulfation of Synthetic Cao-Based Sorbents in Calcium Looping Cycle

Synthesis, Experimental Studies, and Analysis of a New Calcium-Based Carbon Dioxide Absorbent

Effect of Doped Lanthanum and Aluminum Salts on Calcium Looping Cycle for CO2 Capture

CO 2 capture performance of CaO-based sorbent modified with torrefaction condensate during calcium looping cycles

Characterization of the enhancement effect of Na2CO3 on the sulfur capture capacity of limestones