Abstract:Calcium looping method has been considered as one of the efficient options to capture CO2 in the combustion flue gas. CaO-based sorbent is the basis for application of calcium looping and should be subjected to the severe calcination condition so as to obtain the concentrated CO2 stream. In this research, CaO/CaZrO3 sorbents were synthesized using the sol–gel combustion synthesis (SGCS) method with urea as fuel. The cyclic reaction performance of the synthesized sorbents was evaluated on a lab-scaled reactor system through calcination at 950°C in a pure CO2 atmosphere and carbonation at 650°C in the 15% (by volume) CO2. The mass ratio of CaO to CaZrO3 as 8:2 (designated as Ca8Zr2) was screened as the best option among all the synthesized CaO sorbents for its high CO2 capture capacity and carbonation conversion at the initial cycle. And then a gradual decay in the CO2 capture capacity was observed at the following 10 successive cycles, but hereafter stabilized throughout the later cycles. Furthermore, structural evolution of the carbonated Ca8Zr2 over the looping cycles was investigated. With increasing looping cycles, the pore peak and mean grain size of the carbonated Ca8Zr2 sorbent shifted to the bigger direction but both the surface area (SA) ratio Φ and surface fractal dimension Ds decreased. Finally, morphological transformation of the carbonated Ca8Zr2 was observed. Agglomeration and edge rounding of the newly formed CaCO3 grains were found as aggravated at the cyclic carbonation stage. As a result, carbonation of Ca8Zr2 with CO2 was observed only confined to the external active CaO by the fast formation of the CaCO3 shell outside, which occluded the further carbonation of the unreacted CaO inside. Therefore, enough attention should be paid to the carbonation stage and more effective activation measures should be explored to ensure the unreacted active CaO fully carbonated over the extended looping cycles.

Synthesis and Performance of a Nano Synthetic Ca-based Sorbent for High Temperature CO_2 Capture

Properties of a Nano CaO/Al2O3 CO2 Sorbent

Properties of a Nano CaO/Al<sub>2</sub>O<sub>3</sub>CO<sub>2</sub>Sorbent

Wet Mixing Combustion Synthesis of CaO-based Sorbents for High Temperature Cyclic CO2 Capture

CO2 Capture Performance of CaO-Based Sorbents Prepared by a Sol–Gel Method

Manufacture of Calcium-Based Sorbents for High Temperature Cyclic CO2 Capture Via a Sol–gel Process

Reactivity and Microstructure of Synthetic CaO-based Sorbents for CO2 Capture

SGCS-made Ultrafine CaO/Al2O3 Sorbent for Cyclic CO2 Capture

Development and performance of CaO/La2O3 sorbents during calcium looping cycles for CO2 capture

Co2 Capture Performance of Calcium-Based Sorbents in A Pressurized Carbonation/Calcination Loop

Developing a Novel CaO-Based Sorbent for Promoted CO2 Capture and Tar Reduction

Development of A Cao-Based Sorbent with Improved Cyclic Stability for Co2 Capture in Pressurized Carbonation

Structure and Surface Insight into a Temperature-Sensitive CaO-based CO2 Sorbent

Preparation and Application of the Sol–Gel Combustion Synthesis-Made CaO/CaZrO3 Sorbent for Cyclic CO2 Capture Through the Severe Calcination Condition

Effect of Preparation Temperature on Cyclic CO2 Capture and Multiple Carbonation−Calcination Cycles for a New Ca-Based CO2 Sorbent

Preparation And Application Of The Sgcs-Made Cao/Zro2 Sorbent For Cyclic Co2 Capture

A green and scalable synthesis of highly stable Ca-based sorbents for CO2 capture

Performance and Carbonation Kinetics of Modified CaO-Based Sorbents Derived from Different Precursors in Multiple CO2 Capture Cycles

Cyclic Performance Of Waste-Derived Sio2 Stabilized, Cao-Based Sorbents For Fast Co2 Capture

Performance of Coal Fly Ash Stabilized, CaO-based Sorbents under Different Carbonation–Calcination Conditions

Synthesis of CaO-based Sorbents Through Incorporation of Alumina/aluminate and Their CO2 Capture Performance