Abstract:Calcium hexaluminate (CA 6 ) has good chemical stability under H 2 atmosphere, which indicates its application prospect in the hydrogen metallurgy field. However, iron ores usually contain SiO 2 impurities, which can react with H 2 to form Si-containing gases such as SiO (g) and SiO 2 (g). The Si-containing gases might corrode CA 6 -based lining refractories during hydrogen metallurgy. The silica and magnetite were heated in a hydrogen furnace to simulate the gaseous environment of hydrogen metallurgy in this paper. At the same time, the corrosion of CA 6 materials at elevated temperature (600 °C–1800 °C) under the hydrogen metallurgy atmosphere were studied. In addition, three SiO 2 based raw materials (silica, fused silica and waste silica brick) with different SiO 2 contents were used to investigate the effect of impurities on the their H 2 corrosion. The result showed that SiO 2 based raw materials had good chemical stability under H 2 atmosphere at the temperature lower than 1200 °C, obvious weight loss appeared at 1400 °C, the impurities including Fe 2 O 3 and MgO would accelerate mass loss under H 2 atmosphere. Gases including SiO (g), SiO 2 (g) and H 2 O (g) could react with CA 6 to form corundum and yoshiokaite at 1800 °C, which resulted in 3.16% weight gain after heating at 1800 °C for 8 h under the hydrogen metallurgy atmosphere. No significant mass change and mineral phase transformation appeared at the reaction temperature less than 1600 °C.

Water Vapor Corrosion Behavior of Scandium Silicates at 1400°C

Corrosion behavior of Yb4Hf3O12 ceramics exposed to Calcium-Ferrum-Alumina-Silicate (CFAS) coupled with water vapor at 1400 °C

Internal Friction Behavior Of Sic Ceramics Subjected To Water Vapor Corrosion

CORROSION BEHAVIOR OF SUPER-AUSTENITIC STAINLESS STEEL AL-6XN IN SUPERCRITICAL WATER

The corrosion behavior of Sc2O3-Y2O3 co-doped ZrO2 influenced by Sc2O3 content in CMAS at 1300 °C

The Oxidation Behavior and Corrosion Mechanism of SiC Matrix Ceramics in a High Temperature Wet Air Environment

The Comparative Investigation of Oxidation Behavior and Corrosion Mechanisms of SiC Matrix Ceramics under Different Atmospheres

Water vapor corrosion behaviors of plasma sprayed ytterbium silicate coatings

Corrosion Kinetics and Mechanisms of ZrC1-x Ceramics in High Temperature Water Vapor

High temperature corrosion behavior and the inhibition of apatite formation evolving from corrosion of (Y1−Yb )2SiO5 in water vapor environment

Corrosion Behavior of Oxide Dispersion Strengthened Ferritic Steels in Supercritical Water

Insights into Oxidation and Nitridation of Alumina-Forming FeCrAl Alloy after Supercritical Water Exposure: Effect of Pre-Corrosion on High-Temperature Damage Behavior

Microstructure and water corrosion behavior of (Lu0.2Yb0.2Er0.2Tm0.2Sc0.2)2Si2O7 high-entropy rare-earth disilicate coating for SiC coated C/C composites

The impact of water and oxygen contents on the corrosion performance of yttrium silicate modified SiC f /SiC composites under high temperature conditions

Effect of water vapor content on the corrosion mechanism of HR3C in simulated oxy-coal combustion environment

Gas corrosion behavior of calcium hexaluminate materials for hydrogen metallurgy

Microstructural and mechanical evolution of SiCf/SiC composites in wet oxygen atmosphere above 1000 degrees C

Water Vapor Corrosion Behavior of Yb2SiO5 Environmental Barrier Coatings Prepared by Plasma Spray-Physical Vapor Deposition

Corrosion Behavior of Alumina-Forming and Oxide Dispersion Strengthened Austenitic 316 Stainless Steel in Supercritical Water

High Temperature Oxidation of Alloy 617, 740, HR6W and Sanicro 25 in Supercritical Water at 650°C

Corrosion Behavior and Mechanisms of Al2O3 and Mo Coated Zircaloy-4 in High-Temperature Lithiated Water