Abstract:This paper investigates the effect of an open hole on the stability of a compressed laminated composite plate. The study was carried out in two ways: using experimental tests and numerical analysis. As a result of the experiment, the buckling form and path of the plate were recorded. The form of buckling was determined using the ARAMIS non-contact measurement system. The critical load value was determined from the working path using the approximation method. The experimental results were verified by numerical analysis based on the finite element method. FEM investigations were carried out in terms of a linear eigenproblem analysis. This allowed the bifurcation load and the corresponding buckling form of the numerical model of the plate to be determined. Investigating the effect of the hole in the compressed plate at a critical state showed high agreement between the proposed test methods. No clear effect of the hole size on the buckling of the plate was observed. In contrast, a clear effect of the hole on the critical load value was determined. The maximum decrease in the critical load value was 14%. The same decrease was observed for the stiffness of the post-critical characteristics. It was shown that the [45|−45|90|0]s composite plate had more than three times lower strength compared to [0|−45|45|90]s and [0|90|0|90]s. The novelty of this article is the development of a research methodology based on new interdisciplinary research methods for describing the influence of the central hole on the stability of compressed composite plates. The ABAQUS system was used for the numerical analysis.

The structural intensities of composite plates with a hole

Micro Failure Analysis of Fiber Metal Laminates

Structural Intensity of Laminated Composite Plates Subjected to Distributed Force Excitation

A comparative study on failure mechanisms of open-hole and filled-hole composite laminates: Experiment and numerical simulation

FE Analysis of Stress Concentrations in Composite Plates with Multiple Holes for Zigzag Multi-Fastened Joints

Dynamic anti-planar characteristics of circular holes in laminated structures under the action of line source

Evaluation on compressive properties of composite laminates with a hole reinforced by metal plate

Numerical simulation and experiment validation of variable stiffness composite laminates with open holes under unidirectional tension

Three-Dimensional Elastic-Plastic Analysis of the Interlaminar Stresses for the AS4/PEEK Composite Laminate with a Circular Hole

Tensile Behavior of Double-Hole CFRP Composite with Different Holes Position

Stress Analysis on Finite Orthotropic Composite Plate with a Central Hole under Biaxial Loading

A New Failure Theory and Importance Measurement Analysis for Multidirectional Fiber-Reinforced Composite Laminates with Holes

Numerical Elastic-Plastic Simulation of Interlaminar Stresses in a Notched Angle-Ply Thermoplastic Composite Laminate

Analysis of the Effect of an Open Hole on the Buckling of a Compressed Composite Plate

Investigation of stress distribution and damage behavior caused by forced installation of a composite bolted joint with a hole-location error

Experimental and numerical studies of the open hole tensile strength of drilled‐ and molded‐hole unidirectional laminates

Investigation of Reinforcement Around the Lightening Hole in Composite Plates Under Tension and Shear Loads

The influence of geometric imperfections on post-buckling behavior and free vibrations of a fiber-reinforced composite laminated plate under thermal loading

The competition between buckling and overstress failure of composite laminated plates in compression and shear loads

Effect of Hole Arrangement on Failure Mechanism of Multiple-Hole Fiber Metal Laminate under On-Axis and Off-Axis Loading

Progressive Failure Analysis of an Open-Hole Composite Laminate by Using the S-Version Finite-Element Method