Abstract:To investigate the bearing characteristics of single piles under the combined action of vertical loads (V) and torque (T) on a pile head, the displacement governing equations of the pile shaft were proposed in consideration of the load transfer method, and the nonlinear solution of a single-loaded pile (vertical load or torque) was calculated by the finite difference method. According to the above mentioned investigation, a new numerical analysis model was proposed to modify the vertical and circumferential ultimate friction resistance of the pile side. Subsequently, the nonlinear solutions of single piles under the combined loads of V-T loading with different loading paths were obtained by MATLAB programming, and the bearing capacity envelopes were plotted. Based on the comparison with the existing research results, the correctness of the theoretical calculation method proposed in this article was verified. The results show that compared with a single loaded pile (V or T), with the action of the V-T combined loads, the bearing capacity of a single pile will decrease, and the single piles under the V⟶T loading path will have a higher bearing capacity than those under the T⟶V loading path. When the aspect ratio is comparatively small, the influence of the loading path is negligible; however, when the aspect ratio is comparatively large, it is necessary to avoid the preliminary application of the torque to a single pile to prevent the decrease in the ultimate bearing capacity on account of the formation of the T⟶V loading mode. The deformation of the pile body mainly occurs in the range from 0 to 0.6L, so effective deformation reduction can be achieved by reinforcing the shallow foundation. It is inadvisable for a single friction pile to be used to improve the bearing capacity by increasing the concrete grade.

Bearing mechanism of single pile under combined loads

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Laboratory Model Study on the Pile-Forming Mechanisms and Bearing Deformation Characteristics of CFA Piles

Three-parameter method for slightly inclined single pile with partial pile head fixity under combined vertical and lateral loads

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

A test on base bearing capacity of static drill rooted nodular pile

Analysis of the Bearing Characteristics of Single Piles under Vertical and Torsional Combined Loads

Study on Bearing Capacity of PCC Pile under Complicated Load Condition

Bearing Mechanism and Calculation Method of Screw Pile

Study on enhancement mechanism of ultimate bearing capacity of tapered friction pile

Study on the Load Transfer Model and the Bearing Capacity of Vertically Loaded Piles

Vertical bearing capacity of pile based on load transfer model

Comparative model tests on failure modes of piles with a variable longitudinal section under ultimate load

A METHOD OF ANALYZING LATERALLY LOADED MONOPILES CONSIDERING THE INFLUENCE OF ADDITIONAL RESISTANCE

CALCULATION AND STUDY ON BEARING MECHANISM OF PILE FOUNDATION IN COMPLICATED GROUND

Model Test of Vertical Bearing Capacity of Cast-in-situ X-shaped Concrete Piles

Finite Element Analysis of Bearing Capacity of Pile under Inclined Load in Layered Soil

Studies on pile bearing characteristics in saturated clay under excavation by model tests and a simplified method

Study on vertical bearing characteristic of rigid pile composite foundation