Radio frequency measurement and tuning of a 13 MeV Alvarez-type drift tube linac for a compact pulsed hadron source
Y Lei,Q Z Xing,B C Wang,S X Zheng,R Tang,P F Ma,H Y Zhang,X L Guan,X W Wang,C T Du,Q K Guo,J Li,W Q Guan
DOI: https://doi.org/10.1063/1.5064462
Abstract:This paper describes the radio frequency (RF) measurement and tuning result of a 13 MeV Alvarez-type drift tube linac (DTL) for a compact pulsed hadron source (CPHS) at Tsinghua University. The design, machining, assembly, and alignment of the DTL are presented for integrity. The CPHS project consists of a high-current proton linac (13 MeV, 16 kW, peak current of 50 mA, 0.5 ms pulse width at 50 Hz), a neutron target station, a small-angle neutron scattering instrument, and a neutron imaging/radiology station. The linac contains an electron cyclotron resonance ion source, a low energy beam transport line, a four-vane radio frequency quadrupole (RFQ) accelerator, an Alvarez-type DTL, a high energy beam transport line, and a RF power supply and distributor. Construction on the CPHS started in June 2009, and the CPHS has provided 2000 h since 2013 to users with the neutrons produced by the 3 MeV proton beam from the radio frequency quadrupole bombarding on the beryllium target as an achievement of its mid-term objective. Presently, the tuning of the assembled DTL cavity has been completed successfully. The 4.3-m-long DTL consists of 40 accelerating cells, among which 39 full-length drift tubes (DTs) are suspended inside the cavity, and two half-length DTs are mounted inside the two end flanges of the cavity. Each DT contains a permanent magnet quadrupole. Thirteen post couplers and nine tuners are available for the tuning of the field. The relative error of the field after tuning is within ±1.6%, with a tilt sensitivity within ±33%/MHz in all cells. The beam energy will reach its designed value of 13 MeV after the DTL is installed in the beam line downstream the 3 MeV RFQ accelerator.