Abstract:The paper describes physical and numerical simulations of a manufacturing process composed of hot forging and controlled cooling, which replace the conventional heat treatment technology. The objective was to investigate possibilities and limitations of the heat treatment with the use of the heat of forging. Three steels used to manufacture automotive parts were investigated. Experiments were composed of two sets of tests. The first were isothermal (TTT) and constant cooling rate (CCT) dilatometric tests, which supplied data for the identification of the numerical phase transformation model. The second was a physical simulation of the sequence forging-cooling on Gleeble 3800, which supplied data for the validation of the models. In the numerical part, a finite element (FE) thermal-mechanical code was combined with metallurgical models describing recrystallization and grain growth during forging and phase transformations during cooling. The FE model predicted distributions of the temperature and the austenite grain size in the forging, which were input data for further simulations of phase transformations during cooling. A modified JMAK equation was used to calculate the kinetics of transformation and volume fraction of microstructural constituents after cooling. Since the dilatometric tests were performed for various austenitization temperatures before cooling, it was possible to include austenite grain size as a variable in the model. An inverse algorithm developed by the authors was applied in the identification procedure. The model with optimal material parameters was used for simulations of hot forging and controlled cooling in one of the forging shops in Poland. Distributions of microstructural constituents in the forging after cooling were calculated. As a consequence, various cooling sequences during heat treatment could be analyzed and compared.

Numerical Simulation of Hot Forging Process for TC4 Blade

Numerical Simulation of Hot Die Forging Process of Ti-6Al-4V Alloy Blade

Microstructure simulation of TC4 blade precision forging process based on multiple field coupling analysis

Finite Element Simulation of Grain Size During Isothermal Forging Process of the TC4 Aerofoil Blade

A Review on the Numerical Simulation Technology of Aerofoil Blade Precision Forging Process

3D Coupled Thermo-Mechanical FEM Simulation in Precision Forging Process of Blade with Tenon

Numerical Simulation of GH4169 Alloy Disc Forging Process on Counterblow Hammer

3D Numerical Simulation of Axial Closed Dies Rolling Process for Disk Forging

The Simulation of Radial Warm Forging Process of TC4 Alloy

Numerical Simulation and Experimental Study on Forging Process of Ultra-Super-critical HP-IP Rotor Steel

RESEARCH ON INFLUENCE OF TEMPERATURE ON A PRECISION FORGING PROCESS OF BLADE WITH A TENON

Numerical Simulation of Pre-forging for Connecting Rod of Automobile Engine and Optimization of Its Pre-forging Billet

Thermal Simulation Model of Aero-Engine Blade Material Forging Simulation

Three-Dimensional Finite Element Modelling of Forging of a Titanium Alloy Aerofoil Sectioned Blade

Process optimization for isothermal forging of TiAl compressor blade by numerical simulation

Numerical simulation of grain size during isothermal forging of TC6 alloy

Physical and Numerical Simulations of Closed Die Hot Forging and Heat Treatment of Forged Parts

Numerical Simulation in Hot Extrusion Processes for Steam Turbo-Generator Blades of AZ31 Magnesium Alloy

Numerical simulation of microstructure evolution of flange axle during hot forging

Numerical Simulation of Chamfering and Rounding Process of Heavy Forgings under Different Anvils

On Technological Development of Blade Forging