Abstract:For advanced performance lithium-ion batteries (LIBs) various novel electrode materials with high energy density have been extensively investigated. Cobaltosic oxide (Co3O4), commonly used as an anode in LIBs, has attracted much interest because of its high theoretical specific capacity (890 mAh center dot g(-1)), high tap density, and stable chemical properties. However, its practical use has been hindered because of its low electronic conductivity and poor rate capability. To address these problems, we investigated a liquid phase precipitation method followed by thermal treatment and obtained a unique lamellar Co3O4 powder. Its X-ray diffraction (XRD) diffraction peaks match the standard pattern for cubic phaseCo(3)O(4) with good crystallinity. We found that the Co3O4 powder consists of many irregular sheets (1.5-3.0 mu m in diameter, 100-300 nm in thickness) with numerous poles by scanning electronmicroscopy (SEM). Additionally, the surface area was about 30.5m(2) center dot g-1, and this was calculated from BET nitrogen adsorption isotherm measurement data. Remarkably, perfect performance was obtained as evaluated by electrochemical measurements, including a high initial discharge capacity (1444.5 mAh center dot g(-1) at 0.1C) and excellent capacity retention (charge capacity after 50 cycles was still greater than 1100.0 mAh center dot g(-1) at 0.1C). However, its rate capability was still not adequate (75.3% of the first charge capacity after 50 cycles at 1C). To improve the rate capability, commercial carbon nanotubes (CNTs) mixed with the Co3O4 powder was used to enhance the electronic conductivity. The charge capacity retention ratios were 96.3% after 70 cycles at 1C and 97.0% after 50 cycles at 2C. Therefore, enhanced electrochemical performance with impressive rate capability was obtained, as expected.

Effect of Lithia and Substrate on the Electrochemical Performance of A Lithia/Cobalt Oxide Composite Thin-Film Anode

Ternary Perovskite Cobalt Titanate/Graphene Composite Material As Long-Term Cyclic Anode for Lithium-Ion Battery

Electrostatic Spray Deposition of Nanoporous Coo/Co Composite Thin Films As Anode Materials for Lithium-Ion Batteries

Enhanced Electrochemical Performance of Li1.2Mn0.54Ni0.13Co0.13O2 Cathode Material Coated with Li+-conductive Li2SiO3 for Lithium Ion Batteries

Preparation and Electrochemical Performance of Li4Ti5O12/Co3O4 Composite as an Anode of Lithium-Ion Battery

Nanoporous Cuprous Oxide/lithia Composite Anode with Capacity Increasing Characteristic and High Rate Capability

Electrochemical Performance of Nano-Sio2 Modified LiCoO2 Thin Films Fabricated by Electrostatic Spray Deposition (ESD)

Effect of carbon coating on electrochemical performance of Li 1.048 Mn 0.381 Ni 0.286 Co 0.286 O 2 cathode material for lithium-ion batteries

Synthesis and Modification of a Lamellar Co3O4 Anode for Lithium-Ion Batteries

Cobalt Ferrite Thin Films As Anode Material for Lithium Ion Batteries

LiCoPO4-based ternary composite thin-film electrode for lithium secondary battery

Electrodeposited Carbon@fe2o3 Composites As Binder-Free Anodes for Lithium Ion Batteries

Carbonate-assisted hydrothermal synthesis of porous hierarchical Co3O4/CuO composites as high capacity anodes for lithium-ion batteries

Synthesis and electrochemical performances of carbon-coated and Ni-doped LiFePO4 anode materials

Improving Electrochemical Cycling Stability of Ni‐rich LiNi0.91Co0.06Al0.03O2 Cathode Materials Through H3BO3 and Y2O3 Composite Coating

Morphology Effect on the Electrochemical Performance of NiO Films As Anodes for Lithium Ion Batteries

Electrochemical performances of NiO/Ni2N nanocomposite thin film as anode material for lithium ion batteries

Tuning the Ratio of Al2O3 to LiAlO2 in the Composite Coating Layer for High Performance LiNi0.5Mn1.5O4 Materials

Improving Electrochemical Cycling Stability of Ni‐rich LiNi 0.91 Co 0.06 Al 0.03 O 2 Cathode Materials through H 3 BO 3 and Y 2 O 3 Composite Coating

Characterization of Thin‐Film Rechargeable Lithium Batteries with Lithium Cobalt Oxide Cathodes

Constructing Co<sub>3</sub>O<sub>4</sub> Nanowires on Carbon Fiber Film as a Lithiophilic Host for Stable Lithium Metal Anodes