Abstract:In 2000, Tarascon et al. revealed the reversible conversion reaction based on the size effect of nanoparticles in metal oxide system, whose theoretical capacity is up to 1000mAh·g-1[1]. However, except large capacity, metal oxide as anode material has its own drawbacks. For example, the electronic conductivity of metal oxides is usually poor, and some of them will form alloy with lithium during the reaction process which cause huge volume change. In order to overcome these obstacles, lots of methods have been presented. Mainly includes the following ways: 1) Fabricating thin film materials, 2) Synthesizing nanostructured materials, 3) Doping or preparing composite materials. Further works showed the doping is effective and convenient in thin film fabrication, and the composite thin films usually obtained better performance than the single system. NiO-NiSe nanocomposite films were fabricated by plused laser deposition. Charge/discharge measurements, cyclic voltammograms and AC impedance tests were used to investigate cyclic performance and electrochemical properties of the materials. X-ray diffraction (XRD), scanning electron microscopy (SEM), high resolution transmission electron microscopy (HRTEM) and selected area electron diffraction (SAED) were employed to detect the structure, morphology and composition of these nanocomposite films in certain electrochemical states. In addition, the electrochemical reaction mechanism of the films versus Li were discussed. The results indicated that: Compared with the single system NiO or NiSe, the transfer resistance of lithium ion in NiO-NiSe nanocomposite thin film is smaller. NiO-NiSe electrode also exhibited a little higher discharge-charge capacity and better cycle performance. After 50 cycles, a reversible capacity of 495mAh.g-1 can still be obtained. NiO-NiSe nanocomposite film also has good rate capability and is more suitable for lithium-ion battery anode material. The electrochemical reaction mechanism investigation showed that NiO and NiSe in the electrode reacted with lithium separately and could be reversibly reproduced.

Electrochemical performances of NiO/Ni2N nanocomposite thin film as anode material for lithium ion batteries

Oxalate-derived porous prismatic nickel/nickel oxide nanocomposites toward lithium-ion battery

Electrochemical Properties of NiO–Ni Nanocomposite As Anode Material for Lithium Ion Batteries

Ionic Conductive Interface Boosting High Performance LiNi0.8Co0.1Mn0.1O2 for Lithium Ion Batteries

High-pseudocapacitance of porous and square NiO@NC nanosheets for high-performance lithium-ion batteries

Composite NiO-NiSe Thin Film Fabricated by Pulse Laser Deposition As a New Anode of Lithium Ion Batteries

Enhanced Reaction Kinetics and Structure Integrity of Ni/SnO2 Nanocluster Toward High-Performance Lithium Storage.

Low-Temperature Metal-Catalysed Synthesis of Metal Oxide Nanoparticles Encapsulated and Nitrogen-doped Carbon Nanotubes from Carbon Nitride as Anodic Materials of High-Performance Lithium-Ion Batteries

Electrochemical energy storage of NiO/NiFe2O4 nanosheets derived from Ni-Fe layered double hydroxides

In-situ electrolytic synthesis and superior lithium storage capability of Ni–NiO/C nanocomposite by sacrificial nickel anode in molten carbonates

Hollow Ni/NiO@N-doped Porous Carbon for Lithium Ion Battery Anode Based on Dual-Buffering Strategy

NiO/Graphene Nanocomposite As Anode Material for Lithium–Ion Batteries

Pulsed Laser Deposited NiO–NiSe Nanocomposite As a New Anode Material for Lithium Storage

High lithium storage performance of Ni0.5Fe0.5O1−xNx thin film with NiO-type crystal structure

NiCo2O4/biomass-derived carbon composites as anode for high-performance lithium ion batteries

Stable Cyclic Performance of Nickel Oxide–carbon Composite Anode for Lithium-Ion Batteries

In Situ Fabrication of Nano Porous NiO-Capped Ni3P Film As Anode for Li-Ion Battery with Different Lithiation Path and Significantly Enhanced Electrochemical Performance

Facile Hydrothermal Fabrication of an α-Ni(OH) 2 /N-Doped Reduced Graphene Oxide Nanohybrid as a High-Performance Anode Material for Lithium-Ion Batteries

Spherical Li4Ti5O12/NiO Composite With Enhanced Capacity and Rate Performance as Anode Material for Lithium-Ion Batteries

Fabrication and Electrochemical Properties of SnO2/Ni Composite Anodes for Lithium Ion Batteries

A Review on Recent Advancements of Ni-NiO Nanocomposite as an Anode for High-Performance Lithium-Ion Battery