Abstract:A 3D thermo-mechanical constitutive model for the polycrystalline shape memory alloy (SMA) has been used to predict the superelastic response of the textured thin-walled NiTi tubes under combined tension–torsion loading. This model is based on the work of Lim et al. and Wang. Considering the difference of Young’s modulus between austenite and martensite phase, some formulas have been modified. The new developed model has been implemented into ABAQUS as UMAT. In order to validate the model, thin-walled tube has been tested under biaxial loading. From the comparison between the simulated and experimental results, it is found that the model is quite good in predicting the overall loading–unloading process of the SMA. Both the experimental and simulated results demonstrate the significant differences in the superelastic responses under different biaxial loading paths. For both biaxial loading paths, at relatively low level of tensile strain, the overall behaviour of the tubes is smooth. But with the increase of the tensile strain level, the equivalent stress–strain curves fluctuate. For torsion–tension loading program, corresponding to about 4% strain, stress decrease upon tensile loading and stress increase upon tensile unloading are observed due to the change of shear stresses. For Type II loading program (tension followed by torsion, unload in reverse order), a stress decrease upon loading and a stress increase upon unloading are observed but the corresponding strains become big with the increase of the tensile strain level. In addition, according to the simulated results, the rate of martensite formation under tensile loading is higher than that under shearing loading.

Theoretical and Experimental Studies of Torsion Deformation of A Thin-Walled Tube with Wound and Pasted Shape Memory Alloy Wires

Modeling Microstructure Evolution in Shape Memory Alloy Rods Via Legendre Wavelets Collocation Method

Modelling and Experimental Study of Shape Memory Alloys Coil Spring Actuator

Experimental and Numerical Study of the Superelastic Behaviour on NiTi Thin-Walled Tube under Biaxial Loading

Study on thermo-mechanical behaviors of shape memory alloy torsion tube

Mechanical Behaviors of Torsion Actuator of Shape Memory Alloy

Constitutive Model for Shape Memory Alloy Torsion Actuator

Modeling and Simulation of SMA Wire Actuator

Investigation on Thermo-Mechanical Behaviors of Shape Memory Thin-Walled Tube

Torsional actuation and vari-stiffness characteristics of SMA/basalt hybrid braided composite tubes

Determining the Up-Down-Up Response Through Tension Tests of A Pre-Twisted Shape Memory Alloy Tube

Experimental Study of Superelasticity of Ni-Ti Shape Memory Alloy Wires

A Thermomechanically Coupled Finite Deformation Constitutive Model for Shape Memory Alloys Based on Hencky Strain

Finite Element Analysis of Pseudoelastic Behavior of Niti Shape Memory Alloy with Thin-Wall Tube under Extension-Torsion Loading

Modeling and Experimental Study on a New Electric-thermal Heating Method for Shape Memory Alloy Wire Actuators

Experimental Study of the Biaxial Cyclic Behavior of Thin-Wall Tubes of NiTi Shape Memory Alloys

Design of a Novel Flexible Shape Memory Alloy Actuator with Multilayer Tubular Structure for Easy Integration into a Confined Space

Thermomechanical response and elastocaloric effect of shape memory alloy wires

Experimental and Numerical Studies on a Novel Shape-Memory Alloy Wire–woven Trusses Capable of Undergoing Large Deformation

Curvature effect on the mechanical behaviour of a martensitic shape-memory-alloy wire for applications in civil engineering

Investigation on Mechanical Behaviors of Shape Memory Alloy Torsion Rod