Abstract:The thermal mechanical properties of shape memory alloy Ni47Ti44Nb9 under pure tension and pure torsion up to an equivalent strain of 16% at M-s + 30 degrees C and other temperatures, and the subsequent heating-induced recovery were investigated experimentally with an MTS 858 tensile-torsional testing system. It was found that the equivalent stress strain curves under pure tension are distinctly different from that under pure torsion, the stress drop and the following plateau in the sigma-epsilon curves as well as the macroscopic martensite band on the surface of the specimens under pure tension were not found in the results under pure torsion, where the shear stress develops monotonically with the increase of shear strain. In both pure tension and pure torsion, the equivalent stress for forward transformation increases with the increase of temperature. During heating-induced recovery, inverse transformation occurs at the onset of heating at a small rate but develops intensively at A(s). The equivalent critical transformation stresses and the inverse transformation temperatures in both pure tension and pure torsion are similar, which may be beneficial for the analysis of the thermal-mechanical response of the material subjected to complex loading histories. As the temperature is sufficiently high so that the applied stress would not be able to induce martensitic transformation and the following reorientation, plastic deformation may take place as the applied stress reaches the yield stress. The comparison between the thermal-mechanical behavior under pure tension and that under pure torsion implies the rationality of the application of von-Mises equivalent rule in describing the constitutive behavior of the material. (C) 2014 Elsevier B.V. All rights reserved.

Investigation on Mechanical Behaviors of Shape Memory Alloy Torsion Rod

Analysis of thermo-mechanical behavior of shape memory alloys

Mechanical Behaviors of Torsion Actuator of Shape Memory Alloy

Investigation on Thermo-Mechanical Behaviors of Shape Memory Thin-Walled Tube

Study on thermo-mechanical behaviors of shape memory alloy torsion tube

Experimental Observations on Mechanical Response of Three-Phase Niti Shape Memory Alloy under Uniaxial Tension

Effect of Thermomechanical Coupling on Stress-Induced Martensitic Transformation Around the Crack Tip of Edge Cracked Shape Memory Alloy

Experimental Investigation to Thermal–mechanical Behavior of Ni47Ti44Nb9 SMA under Pure Tension and Pure Torsion

On Phase Transition Velocities of NiTi Shape Memory Alloys

Experimental Investigation on the Mechanical Instability of Superelastic NiTi Shape Memory Alloy

Investigation on the Deformation of TiNi Shape Memory Alloy with a Crack Using Moiré Interferometry

Investigation On Deformation Mechanisms Of Niti Shape Memory Alloy Tube Under Radial Loading

Investigation on Stress Field near Crack-Tip of Mode I in Shape Memory Alloy

Comparative study on mechanical and shape memory properties of hot forged NiTiNb in axial and radial direction

Thermodynamic Performance Test and Phenomenological Constitutive Model of NiTiNb Shape Memory Alloy

Experimental investigation of thermomechanical behaviour of NiTi shape memory alloy under low-velocity impact loading

Microstructure, Mechanical Property, and Phase Transformation of Quaternary NiTiFeNb and NiTiFeTa Shape Memory Alloys

Experimental Investigation on Local Mechanical Response of Superelastic NiTi Shape Memory Alloy

Numerical Simulation on Uniaxial-tension Behavior of Shape Memory Alloy Films

Study on Martensite Phase Transformation near Crack Tip of Mode II in Shape Memory Alloy

High-Cycle Fatigue Mechanisms of a NiTi Shape Memory Alloy under Different Mean Strains