Abstract:A 3D thermo-mechanical constitutive model for the polycrystalline shape memory alloy (SMA) has been used to predict the superelastic response of the textured thin-walled NiTi tubes under combined tension–torsion loading. This model is based on the work of Lim et al. and Wang. Considering the difference of Young’s modulus between austenite and martensite phase, some formulas have been modified. The new developed model has been implemented into ABAQUS as UMAT. In order to validate the model, thin-walled tube has been tested under biaxial loading. From the comparison between the simulated and experimental results, it is found that the model is quite good in predicting the overall loading–unloading process of the SMA. Both the experimental and simulated results demonstrate the significant differences in the superelastic responses under different biaxial loading paths. For both biaxial loading paths, at relatively low level of tensile strain, the overall behaviour of the tubes is smooth. But with the increase of the tensile strain level, the equivalent stress–strain curves fluctuate. For torsion–tension loading program, corresponding to about 4% strain, stress decrease upon tensile loading and stress increase upon tensile unloading are observed due to the change of shear stresses. For Type II loading program (tension followed by torsion, unload in reverse order), a stress decrease upon loading and a stress increase upon unloading are observed but the corresponding strains become big with the increase of the tensile strain level. In addition, according to the simulated results, the rate of martensite formation under tensile loading is higher than that under shearing loading.

Mechanical Behaviors of Torsion Actuator of Shape Memory Alloy

A phenomenological constitutive model for one-dimensional shape memory alloys based on artificial neural network

Modelling and Experimental Study of Shape Memory Alloys Coil Spring Actuator

Study on thermo-mechanical behaviors of shape memory alloy torsion tube

Constitutive Model for Shape Memory Alloy Torsion Actuator

Modeling and Simulation of SMA Wire Actuator

Investigation on Mechanical Behaviors of Shape Memory Alloy Torsion Rod

Investigation on Thermo-Mechanical Behaviors of Shape Memory Thin-Walled Tube

A Thermomechanically Coupled Finite Deformation Constitutive Model for Shape Memory Alloys Based on Hencky Strain

Theoretical and Experimental Studies of Torsion Deformation of A Thin-Walled Tube with Wound and Pasted Shape Memory Alloy Wires

A Three-Dimensional Constitutive Model for Shape Memory Alloy Considering Transformation-Induced Plasticity, Two-Way Shape Memory Effect, Plastic Yield and Tension-Compression Asymmetry

Analysis of thermo-mechanical behavior of shape memory alloys

Experimental and Numerical Study of the Superelastic Behaviour on NiTi Thin-Walled Tube under Biaxial Loading

A Three-Dimensional Constitutive Model for Shape Memory Alloy

A Constitutive Model for Shape Memory Alloy in Pure Shear State

Design,Modeling and Simulation of a New-style Fiber Shape Memory Alloy Actuator

A Three-Dimensional Constitutive Modeling for Shape Memory Alloys Considering Two-Way Shape Memory Effect and Transformation-Induced Plasticity

Design Methodology of the Ni50Ti50 Shape Memory Alloy Beam Actuator: Heat Treatment, Training and Numerical Simulation

A THERMO-MECHANICAL CONSTITUTIVE EQUATION FOR SHAPE MEMORY ALLOY

Tensile Test of Shape Memory Alloys and Numerical Simulation

Thermomechanical Description of Shape Memory Alloys Using the Preisach Model