FEM Simulation and Experiment Verification of the Monocrystal Silicon Nanoindentation Process

Chen Zhang,Su Wei,Wan Min
DOI: https://doi.org/10.3969/j.issn.1671-4776.2009.02.008
2009-01-01
Abstract:2D axisymmetric finite element model(FEM)was established for monocrystal silicon nanoindentation process with commercial finite element software package ABAQUS.The effect of the indenter tip radius and the friction coefficient between the nano-indenter and sample material on the nanoindentation process were discussed by analyzing the load-displacement curves from simulation.The experiments were made with Triboindenter of Hysitron,Inc.to verify the effectiveness of simulation results.For a given indentation depth,the applied load and elastic recovery increases with a tip radius increasing.The change of friction coefficient influences quite little on indentation process,which is ignored during the simulation.Comparing the simulation and experiment curves,an obvious elbow is discovered in experimental curves,because of phase transformation induced by high pressure,which causes complex constitutive relations during nanoindentation for which FEM hasn't this model.
What problem does this paper attempt to address?