Abstract:To evaluate and improve the efficiency of photovoltaic solar modules connected with linear pipes for water supply, a three-dimensional numerical simulation is created and simulated via commercial software (Ansys-Fluent). The optimization utilizes the principles of the 1st and 2nd laws of thermodynamics by employing the Response Surface Method (RSM). Various design parameters, including the coolant inlet velocity, tube diameter, panel dimensions, and solar radiation intensity, are systematically varied to investigate their impacts on energetic and exergitic efficiencies and destroyed exergy. The relationship between the design parameters and the system responses is validated through the development of a predictive model. Both single and multi-objective optimizations are performed using the predictive model to optimize the thermal and electrical productivity under different scenarios. The findings indicate the significance of the thermal exergy effectiveness, as evidenced by its low P-value for all solar system responses, indicating its crucial role in the predictive model. For single-objective optimization, the desirability is equal to 1 in cases where only heat transfer efficiency, whole energy effectiveness, or thermal exergy efficiency is maximized or only destroyed exergy is minimized. The improvements in energy and exergy efficiencies range from 3.55% to 69.13%, with the amount of destroyed exergy reduced by 81.47% compared to the base case. For multi-objective optimization, desirability values exceeding 0.829 and 0.655 are obtained for single and multi-objective scenarios, respectively, indicating that the expected performance is within desirable limits. The findings provide valuable insights for designing high-efficiency photovoltaic/thermal systems and addressing their challenges and limitations.

Heat Dissipation Design of Photovoltaic Inverter Based on Analysis of Flotherm

Analysis on a Photovoltaic-Integrated Solar-Assisted Heat Pump Water Heater

Mission Profile Based Multi-Disciplinary Analysis of Power Modules in Single-Phase Transformerless Photovoltaic Inverters

Simulation of Heat Dissipation in a Closed Enclosure Based On Flotherm

Design of Heat Sink for Electric Vehicle SiC MOSFET Air-cooled Inverter

Design of High Efficiency Inverter with Air Cooling for Electric Vehicle

Heat Dissipation Design of Sub-module in Modular Multilevel Converter

Numerical study on natural, forced and mixed convection of a hybrid photovoltaic inverter

Optimization of Motor Heat Dissipation Systems Based on Three Dimensional Flow Field Analysis

Loss Analysis and Thermal Design of Mid Voltage & Mine-Used Inverter Main Circuit

Thermal Analysis on Active Heat Dissipation Design with Embedded Flow Channels for Flexible Electronic Devices

Research on Heat Dissipation and Cooling Optimization of A Power Converter in Natural Convection

Heat Pipe-Based Cooling Enhancement for Photovoltaic Modules: Experimental and Numerical Investigation

Modelling and analysis of a liquid-cooled system for thermal management application of an electronic equipment

Optimizing performance of water-cooled photovoltaic-thermal modules: A 3D numerical approach

Numerical Study on 2-Stage Phase Change Heat Sink for Cooling of Photovoltaic Panel

Performance Analysis and Structural Optimization of a Finned Liquid-Cooling Radiator for Chip Heat Dissipation

Thermal evaluation of photovoltaic panels combined pulsating heat pipe with phase change materials: numerical study and experimental validation

Modeling and Simulation Analysis of Photovoltaic Photothermal Modules in Solar Heat Pump Systems

Exergy Analysis of a High Concentration Photovoltaic and Thermal System for Comprehensive Use of Heat and Electricity

Theoretical Study of a Novel Intermediate Temperature Photovoltaic/thermal System Equipped with Heat Pipe and Evacuated Tube