Abstract:The shell-and-tube waste heat boiler is a common facility to recover and utilize the energy of flue gas in industries. To improve the ability and efficiency of the boiler, a steam dome is configured above the drum so as to arrange more heat exchange tubes. Simulation and analysis of vapor-liquid two-phase flow across tube bundles arranged in the drum are of vital importance to design and safety operation. Numerical simulation of boiling two-phase flow across tube bundles in the drum was carried out to analyze the shell side thermal-hydraulics. Commercial software ANSYS FLUENT 14.5 was adopted for modeling and computational calculations. The applied modeling approach was validated against experimental results with a good agreement. In order to analyze the vapor-liquid two-phase flow performance under various working conditions, the inlet velocity of downcomer tubes of 3m·s−1, 4m·s−1 as well 5m·s−1 for saturated water were simulated, respectively. The pressure field, flow characteristic, void fraction distribution and heat transfer characteristic were analyzed to have a good knowledge of the boiler operation. The following conclusions have been drawn through analyzing simulation results. (1)The total pressure drop on shell side increased with increasing the inlet velocity of downcomer tubes of saturated water. (2)The velocity of saturated water decreased after flowing into the drum less than z = 0.1m as the flow area increasing, and then increased rapidly as the volume of the mixture two-phase flow increasing. (3)The integral average void fraction of the drum decreased as the mass flow rate of inlet saturated water increasing. (4)The HTC (heat transfer coefficient) of the heat exchange tubes varied with the flow direction, which is related to the vapor-water void fraction. The conclusions obtained above can be used as a reference for the design of the separated structure shell-and-tube waste heat recovery boiler.

Some Questions on Design and Calculation for Fire-Tube Heating Boiler

Discussion on Design and Calculation of Shell Type Boiler

Research & Development of Boiler Tube Wall Temperature Calculation System

A New Method and Formula for Structure Design and Calculation of Thermal Stress of Finned Tube Used in Industial Boiler

Method Comparison for Thermal Calculation of Water Jacket Heater

Optimization Research On The Power Boiler Furnace Performance Design Method

Fluid Flow, Heat Transfer, and Thermal Stress in Tube Sheet Cooling Chamber of Fire Tube Waster Heat Boiler

The Cold Hydrodynamic Characteristics Experiment and Study of Small Type Water-fire Tube Hot Water Boilers

Investigation on two Design Schemes for a Middle-parameter Full Blast Furnace Gas Boiler

Experimental Study on Flow and Heat Transfer Performance of Condensing Gas-Fired Boiler

Calculation of the Temperature Field Distribution in an Electrically Heated Inclined Tube

Design and Operation of Experimental System for Studying Heat Transfer in a Smooth Tube at Near and Super Critical Pressure

Heat Flux Distribution on Circulating Fluidized Bed Boiler Water Wall

Experimental Study of the Fouling Characteristics of Intensified Heat Transfer Tubes of a Utility Boiler

Numerical Simulation and Experimental Research of Flow Problems of Headers with T-type Three-way Pipe and Parallel Tube Platen System of Utility Boiler

NUMERICAL INVESTIGATION ON TWO-PHASE FLOW CHARACTERISTIC IN THE SEPARATED STRUCTURE SHELL-AND-TUBE WASTE HEAT BOILER

THERMAL CALCULATION OF A CIRCULATING FLUIDIZED BED BOILER FURNACE

COMPARISON ON THE BOILING HEAT TRANSFER CHARACTERISTICS OF STEAM-WATER IN THE INCLINED TUBE AND THE VERTICAL TUBE IN SUB-CRITICAL AND NEAR CRITICAL PRESSURE REGIONS

Study on Calculation Method for Partition of Heat Transfer in an Ultra-supercritical Boiler

Design Theory of Circulating Fluidized Bed Boilers and Determination of the Design Parameters

Study of the Flow and Heat Transfer Characters in the Tube Sheet Cooling Chamber of a Fire Tube Waste Heat Boiler