Abstract:The objective of this study was to create foam from a blend of ABS/TPU (50:50 wt%) by using CO2 as a physical blowing agent. The main goal of this investigation was to determine the impact of different parameters on the expansion ratio and cell structure. This study investigates the cell structure control in 50% thermoplastic polyurethane (TPU) and 50% acrylonitrile butadiene styrene (ABS) blend foam using CO2 as a physical blowing agent, focusing on the effects of variable foaming parameters on the microstructure. Samples measuring 25 × 25 × 1 mm were produced and analyzed for foam structure. The foaming process involved saturating the samples with CO2 gas at pressures of 4, 5.5, and 7 MPa, followed by rapid pressure release and immersion in a hot glycerol bath. The foaming parameters included varied temperatures (80, 90, and 120°C) and times (5–80 s). Scanning electron microscope (SEM) analysis provided data on cell size and density. Results indicated that increasing the saturation pressure enhanced CO2 uptake in the ABS/TPU blend, with the CO2 uptake rate peaking early in the process. Higher foaming temperatures and extended foaming times led to increased cell size, cell density, and expansion ratio. These findings highlight the significant role of process parameters in controlling the cell structure of ABS/TPU blend foams, offering valuable insights into optimizing foam properties for industrial applications. Highlights Optimization of foam parameters leads to cell structure control in ABS/TPU composite foams for industrial applications. Increasing saturation pressure significantly boosts CO2 uptake in ABS/TPU composite foams. Increasing the foaming temperature and duration leads to larger cell sizes, higher cell density, and greater expansion ratios in ABS/TPU composite foams.

Analysis on Gas Diffusion Behavior of ABS Microcellular Foam Material

Research on Microcellular ABS Foam by Compression Molding

Effect of Melt Viscosity on the Cell Morphology and Properties of Poly(lactic Acid) Foams

Tuning cellular structure in a previously developed microcellular acrylonitrile butadiene styrene/thermoplastic polyurethane blend foams

Research on effect of ABS,MAH,DCP on property of PA6/ABS blend

Comprehensive analysis of mechanical properties of microcellular polypropylene: Experiment and simulation

Experimental Measurement of CO2 Diffusion in PMMA and Its Effect on Microcellular Foaming

Study on Foaming Properties of PLA/NCC Microcellular Foam Materials

Preparation and Density Control of Pmma Microcellular Foams Via Supercritical Carbon Dioxide Foaming

Study on Cellular Structure of Acrylonitrile/ Methacylic Acid Copolymer Foam Plastic

Preparation, Characterization, and Mechanical Properties of Microcellular Poly(Aryl Ether Ketone) Foams

Physical Properties of Microcellular Polymeric Foams with Supercritical CO2

OPTIMUM DESIGN OF PROCESS PARAMETERS IN MICROCELLULAR FOAM INJECTION MOLDING

Study on microcosmic properties and temperature simulation of foamed polypropylene composites

Microcellular processing and relaxation of poly(ether ether ketone)

Response Surface Optimization for Producing Microcellular Polymethyl Methacrylate Foam Using Supercritical Co2

Preparation and Properties of Microcellular Foamed PP by New Foaming Agent

Microstructure and Properties of Microcellular Poly (phenylene Sulfide) Foams by Mucell Injection Molding

Research Process of Microcellular Foams Prepared by Supercritical Fluid Technique

Effects of Different Gases on the Molecular Behavior of Alkyl Glycosides at Gas/Liquid Interface and Foam Stability

Regulating cell morphology of poly (lactic acid) foams from microcellular to nanocellular by crystal nucleating agent