Abstract:In this work, resin‐derived carbon coating was prepared on carbon fibers by polymer impregnation pyrolysis method, then silicoboron carbonitride powder was prepared by mechanical alloying, and finally carbon fiber‐reinforced silicoboron carbonitride composites were prepared by hot‐pressing process. The effects of sintering densification and fiber coating on microstructure, mechanical properties, thermal shock resistance, and failure mechanisms of the composites were studied. Fiber bridging hinders the sintering densification, causing more defects in fiber‐dense area and lower strength. However, higher sintering temperature (1800–2000°C) can improve mechanical properties significantly, including bending strength, vickers hardness, and elastic module, because further sintering densification enhances matrix strength and fiber/matrix bonding strength, while the change of fracture toughness is not obvious (2.24–2.38 MPa·m1/2) due to counteraction of higher debonding resistance and less pull‐out length. However, fiber coating improves fracture toughness greatly via protecting carbon fibers from chemical corrosion and damage of thermal stress and external stress. Due to lower coefficient of thermal expansion, lower fiber loading ratio, less stress concentration at the fiber/matrix interface, and better defect healing effect, lower sintering temperature favors thermal shock resistance of composites, and thermal shock recession mechanisms are the damage of interface.

Effect of SiC coating and heat treatment on damping behavior of C/SiC composites

Influence of SiC Coating Thickness on Mechanical Properties of SiCf/SiC Composite

Effects of Interphase Thickness on Damping Behavior of 2D C/SiC Composites

Mechanical Behavior of SiCf/SiC Composites with Alternating PyC/SiC Multilayer Interphases

The Effect of Heat Treatment on the Properties of SiCf/SiC Composites Prepared with Different SiC Fibers

EFFECTS OF HEAT TREATMENT ON THERMAL EXPANSION OF 3D C/SiC COMPOSITES

Residual stress variation in SiCf/SiC composite during heat treatment and its effects on mechanical behavior

Damping performance of SiC nanoparticles reinforced magnesium matrix composites processed by cyclic extrusion and compression

Influence of High-Temperature Oxidation and Test Conditions on the Dynamic Mechanical Properties of 2.5D SiCf/SiCm Composites

EFFECT OF HEAT TREATMENT ON THE MICROSTRUCTURE AND PHYSICAL PROPERTIES OF SiC/Si LAMINATED COMPOSITES

Effects of Carbon Fiber Architecture on the Microstructure and Mechanical Property of C/C-SiC Composites

Effects of Interphase Thickness and Heat Treatment on Transverse Thermal Diffusivity of 3 D C / SiC Composites

Effects of SiC coating on microwave absorption of novel three-dimensional reticulated SiC/porous carbon foam

Behavior of Two-Dimensional C/SiC Composites Subjected to Thermal Cycling in Controlled Environments

Mechanical properties and damping capacity of SiC p /TiNi f /Al composite with different volume fraction of SiC particle

Microstructure and Damping Behavior of Continuous W-Core-SiC Fiber-Reinforced Aluminum Matrix Composites

Influence of Thermal Shock on the Mechanical Behavior of Si-SiC Coated Carbon/Carbon Composites

EFFECTS OF FABRIC ARCHITECTURES ON THE THERMAL EXPANSION COEFFICIENT AND THE THERMAL DIFFUSIVITY OF CARBON FIBER REINFORCED SILICON CARBIDE COMPOSITES

Effect of thermal residual stress on the tensile properties and damage process of C/SiC composites at high temperatures

Mechanical and thermal shock properties of C f /SiBCN composite: Effect of sintering densification and fiber coating

Effects of SiC Content on the Mechanical and Thermophysical Properties of 3D Cf/SiC–Al Composites