Abstract:Cast-in-situ concrete suffers complicated working conditions in sulfate-rich saline soil areas. Sulfate-magnesium combined attack can be encountered in heavy saline or salty lake areas. This study investigated the degradation process and corresponding mechanisms of cast-in-situ concrete, contaminated by chlorides, partially exposed to sulfate-magnesium combined corrosive environments. Concrete samples were cast and partially immersed in the pre-prepared distilled water, sulfate or sulfate-magnesium mixed solutions for 12 months. Physical and mechanical properties of concrete samples were continuously measured and recorded during the immersion. Sulfate concentration in different depths were measured by chemical titration. SEM, XRD, TG/DTG tests were conducted to analyze the microstructural and mineral property changes after corrosion for concrete suffered different corrosion conditions. Results show that partially immersed concrete encounters both chemical and physical degradation induced by corrosive sources. Concrete contaminated by chlorides obviously shows weaker resistance against sulfate attack and the strength development is also negatively affected. Magnesium in the environments reduces the early strength of partially immersed cast-in-situ concrete while enhancing the sulfate resistance ability in the later corrosion stage. Magnesium limits the negative effect of contaminated chlorides on the partially immersed cast-in-situ concrete. Performance of cast-in-situ concrete is different from precast concrete when encountering different corrosive sources, and thus more attention should be paid on the degradation of cast-in-situ concrete structures induce by aggressive environments.

Preliminary experiment study on effectiveness of discrete sacrificial anodes

Intelligentization of traditional sacrificial anode Zn by Mg-alloying for reinforcing steel

Developing a Novel Expression for Chloride Ion Concentration Threshold in Reinforced Concrete: Integration of Electrochemical Analysis and Time-Dependent Modeling

Research on Chloride Appropriate Dosage for Incorporated Accelerated Corrosion

Experimental study on electrical characteristics of ions in concrete at early age under electric field

Effectiveness of an amine-based inhibitor—guanidine for steel in chloride-contaminated concrete

Establishment of electrode potential-composition plot of Al-Mg-Zn alloys and sacrificial anode protection tests

Study on the Splash Zone Corrosion Protection of Carbon Steel by Sacrificial Anode

The Electrochemical Characterization of Rebar Passivation Film in Simulated Concrete Media

Chloride-induced Corrosion Patterns of Reinforcements in Simulated Pore Solutions of Calcium Sulfoaluminate Cement Concrete: an Analytical Study

Applicability Study on Accelerated Corrosion Methods of Steel Bars in Concrete Structure

Effect of the stirrup on the transport of chloride ions during electrochemical chloride removal in concrete structures

Three-phase Modelling of Electrochemical Chloride Removal from Corroded Steel-Reinforced Concrete

A Comparison Study on the Natural and Half-Soaking Galvanic Accelerated Corrosion of Reinforced Concrete Based on an Improved Electrochemical Model

Effects of Cyclic Seawater Exposure on the Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete

Degradation Mechanisms of Chloride Contaminated Cast-in-Situ Concrete Partially Exposed to Magnesium-Sulfate Combined Environment

Influence of Threshold Chloride Concentration on Corrosion Behavior of Low-Alloy Steel Rebar in Concrete Pore Solutions

Experimental Research on Performance of Anti-corrosion Coating Against Chloride Ion Ingress into Concrete

Utilization of Sodium Polyacrylate Hydrogels in the Sacrificial Anode Cathodic Protection Method for Steel Members at the Atmospheric Environment

Electrochemical Investigations of Steels in Seawater Sea Sand Concrete Environments

Threshold Chloride Concentration of Stainless Steels in Simulated Concrete Pore Solution