Abstract:As a promising technique to remove volatile organic compounds (VOCs), non-thermal plasma (NTP) has been paid much attention recently. However, the practical implementation of NTP is limited owing to its disadvantages such as low mineralization rate, unsatisfactory energy efficiency and the generation of multiple byproducts. Reactor configuration optimization and plasma coupled catalysis are the two alternatives to improve the efficiency of NTP. A packed bed double dielectric barrier discharge (DDBD) system was established and the performance of CeO2-Co3O4 catalysts for toluene abatement was evaluated in a sequential process. It was found that complete toluene removal could be achieved in the DDBD reactor packed with different catalysts. Among them, CeO2-Co3O4 binary catalysts showed higher toluene degradation performance than monometallic samples and Ce1Co3 had the best mineralization rate (89.68%) and energy yield (3.04 g/kWh). The effects of Ce/Co ratio on the structural and redox characteristics of the samples were analyzed by BET, XRD, TEM, XPS and H2-TPR. The superior catalytic activity was attributed to the interplay between Ce and Co species, which created abundant defects and oxygen vacancies and improved the concentration of surface adsorbed oxygen and the reducibility of catalyst. The effects of the relative parameters, such as applied voltage, toluene adsorbed amount and discharge time on the toluene degradation efficiency were also explored. Finally, the toluene decomposition mechanism in the DDBD catalytic system was speculated according to the detected organic products. The findings in this work can provide vital insight in plasma catalytic degradation of VOCs by sequential process.

Removal of VOCs catalyzed by carbon composite material under assistance of dielectric barrier discharge

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

VOCs degradation with non-thermal plasma and Ag-MnOx catalysis

Plasma Induced Toluene Decomposition on Alumina-Supported Mn-Based Composite Oxides Catalysts

Characteristics of Back Corona Discharge in a Honeycomb Catalyst and Its Application for Treatment of Volatile Organic Compounds.

Toluene Decomposition by a Two-stage Hybrid Plasma Catalyst System in Dry Air

Characteristics and Mechanism of Toluene Removal by Double Dielectric Barrier Discharge Combined with an Fe2O3/TiO2/γ-Al2O3 Catalyst

Removal of Volatile Organic Compounds (vocs) at Room Temperature Using Dielectric Barrier Discharge and Plasma-Catalysis

Decomposition of toluene by dielectric barrier discharge comnbined with catalytic ozonation

Removal of Toluene by Gliding Arc Discharge Plasma

Experimental Studies of Removing Typical VOCs by Dielectric Barrier Discharge Reactor of Different Sizes

Toluene removal characteristics by a superimposed wire-plate dielectric barrier discharge plasma reactor

In Plasma Catalytic Oxidation of Toluene Using Monolith CuO Foam As a Catalyst in a Wedged High Voltage Electrode Dielectric Barrier Discharge Reactor: Influence of Reaction Parameters and Byproduct Control

Plasma-catalytic oxidation of toluene over MCeZrO x /TiO 2 (M = Cu, Mn, Ni and Co) catalysts using a dielectric barrier discharge reactor

Decomposition of Toluene Using Nanosecond- Pulsed-Discharge Plasma Assisted with Catalysts

Utilizing catalyst to enhance pulse discharge for volatile organic compounds treatment

Double dielectric barrier discharge incorporated with CeO2-Co3O4/γ-Al2O3 catalyst for toluene abatement by a sequential adsorption–discharge plasma catalytic process

Research On Toluene Removal With Non-Thermal Plasma Catalysis Technology

Study of VOCs emission control by activated carbon adsorption-plasma oxidation

Volatile Organic Compounds (vocs) Removal in Non-Thermal Plasma Double Dielectric Barrier Discharge Reactor

Toluene removal by a DBD-type plasma combined with metal oxides catalysts supported by nickel foam