Abstract:The degradation of toluene by non-thermal plasma has been evaluated in a continuous-flow sliding dielectric barrier discharge (SLDBD) reactor based on three-electrode configuration and compared with a traditional surface dielectric barrier discharge reactor. In order to optimize the electrical and geometry parameters of the SLDBD reactor, the effects of positive pulsed high-voltage (U+pulse), negative DC voltage (U−DC), pulse-forming capacitance (Cp)), inter-electrode gap, discharge length, and dielectric material have been systematically investigated. Morphological characterizations demonstrate that the steamer channels can propagate more homogeneously along the dielectric surface when a sufficient U−DC is applied under the condition of slight increase in energy. The average discharge power of the SLDBD reactor mainly depends on U+pulse, while which is less affected by U−DC. Unexpectedly, both toluene degradation efficiency and energy yield using the SLDBD increase significantly as U−DC, indicating that VOC degradation is not only determined by the energy primarily provided by U+pulse, but also depends on the drift of the ionized species induced by U−DC. Increasing Cp enhances the energy injected into the SLDBD reactor and leads to a higher toluene degradation efficiency, but lowers the energy yield when the other parameters remains unchanged. The optimal Cp is 0.67 nF. Shorter inter-electrode gap and longer discharge length appear to be more advantageous in terms of toluene degradation and energy yield. Quartz plate exhibits remarkably better degradation and energy performance than ceramic and polytef ones, leading to the maximum toluene degradation efficiency of 58% and energy yield of 0.85 g/kWh in this work.

Removal of Toluene by Gliding Arc Discharge Plasma

Decomposition of Toluene in A Gliding Arc Discharge Plasma Reactor

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Decomposition of Toluene in A Rotating Glidarc Discharge Reactor

Experimental Studies of Removing Typical VOCs by Dielectric Barrier Discharge Reactor of Different Sizes

VOCs degradation with non-thermal plasma and Ag-MnOx catalysis

Removal of VOCs catalyzed by carbon composite material under assistance of dielectric barrier discharge

Characteristics and Mechanism of Toluene Removal by Double Dielectric Barrier Discharge Combined with an Fe2O3/TiO2/γ-Al2O3 Catalyst

Toluene removal characteristics by a superimposed wire-plate dielectric barrier discharge plasma reactor

Abatement of toluene from gas streams via ferro-electric packed bed dielectric barrier discharge plasma

[Scale-Up Study on Pulse Corona Discharge for the Removal of Toluene].

Removing Toluene by Needle-Plate Streamer Corona Discharge Indroduced Pulse Supply Power

Decomposition of gaseous toluene using a continuous flow discharge plasma reactor with new configurations

Study of VOCs emission control by activated carbon adsorption-plasma oxidation

Simultaneous Removal of Ethyl Acetate, Benzene and Toluene with Gliding Arc Gas Discharge

Research On Toluene Removal With Non-Thermal Plasma Catalysis Technology

Scale-up investigation on pulse corona for the removal of toluene

Scale-up Experiment of Plasma Reactors with Different Electrode Structure

Removal Of Mixed Gaseous Vocs By Pulse Corona Discharge Combined With Absorption Oxidation

Improved Performance for Toluene Abatement in a Continuous-Flow Pulsed Sliding Discharge Reactor Based on Three-Electrode Configuration

Destruction of Toluene by Rotating Gliding Arc Discharge