Abstract:A comprehensive analysis was conducted to examine the crystal phase composition, surface and cross-section morphology, elemental composition, thickness, and corrosion resistance of coatings. X-ray diffraction (XRD) was employed to investigate the texture and crystal phase of the materials while scanning electron microscopy (SEM) and energy-dispersive spectroscopy (EDS) were utilized to assess the surface and cross-section structure. Additionally, electrochemical techniques were employed to evaluate the corrosion performance. Compared to DC electroplating, the corrosion potential of pulsed galvanized ferroalloy alloy coating increased from −1031 mV to −1008 mV, and the corrosion current density decreased from 3.122 × 10−5 A∙cm−2 to 0.321 × 10−5 A∙cm−2. Moreover, the corrosion rate value of the coating obtained by the pulse rectifier (0.386 × 10−5 g m−2 h−1) was lower than that obtained by the DC power supply (3.75 × 10−5 g m−2 h−1). Additionally, pulsed electrodeposition reduced the iron content of the coating by 0.7%, thereby enhancing its corrosion resistance and flatness. The impedance parameters of the zinc–iron alloy coating acquired through the 30% duty cycle monopulser process exhibit superior performance compared to DC electroplating. Evidently, the monopulse coating’s structure enhances crystal packing density, augments coating thickness, improves adhesion to the substrate interface, and optimizes grain distribution uniformity. These factors are crucial determinants of the corrosion behavior exhibited by Ze–Fe coating.

Research of Spangle on Hot Dip Galvanized Steel

Surface characteristics and corrosion resistance of spangle on hot-dip galvanized coating

Spangle Formation on Hot-Dip Galvanized Steel Sheet and its Effects on Corrosion-Resistant Properties

Surface structure characterization and corrosion mechanism study of three types hot-dip galvanized spangles

A Review of Recent Developments in Coating Systems for Hot-Dip Galvanized Steel

The Research on Al-Si Coating for Hot Forming Steel

Study on zinc slag defects on surface of pure hot dip galvanized steel sheet

Study on the Alloy Coatings Properties of the New Rare Earth Yttrium Zinc Aluminum Magnesium

Effects of Alloying Elements on Surface Oxides of Hot-Dip Galvanized Press Hardened Steel

Effects of Al contents on microstructure and properties of hot-dip Zn-Al alloy coatings on hydrogen reduced hot-rolled steel without acid pickling

A review of physical properties of hot-dip galvanized coating layer by layer and their respective electrochemical corrosion behavior

Solidification microstructure of Zn-(0-6.0%)Al-4%Sb alloys used for hot-dip galvanizing

Study of dark dot defect on coating surface of continuously annealed hot-dip galvanized steel sheet

Corrosion Properties of Steel Sheet with Zinc-base Alloyed Coatings

In-Situ Wettability Analysis of Al Coating Influence on Hot-Dip Galvanizing Properties of Advanced High-Strength Steels

Production Process and Technology Development of Hot-Dip Galvanizing

Roles of Al and Mg on the Microstructure and Corrosion Resistance of Zn-Al-Mg Hot-Dipped Coated Steel

A Study on the Influence of the Electroplating Process on the Corrosion Resistance of Zinc-Based Alloy Coatings

In-situ synthesis and performance evaluation of novel color coatings for galvanized steel

The fundamental research on suspended dross in hot dip Al–Zn galvanising process

Corrosion Properties of Steel Sheet with Zinc-Base Alloy Coatings