Abstract:We present the results of the measurements of the detection efficiency for a 4.7 \r{A} neutron beam incident upon a detector incorporating a stack of up to five MultiWire Proportional Counters (MWPC) with Boron-coated cathodes. The cathodes were made of Aluminum and had a surface exhibiting millimeter-deep V-shaped grooves of 45{\deg}, upon which the thin Boron film was deposited by DC magnetron sputtering. The incident neutrons interacting with the converter layer deposited on the sidewalls of the grooves have a higher capture probability, owing to the larger effective absorption film thickness. This leads to a higher overall detection efficiency for the grooved cathode when compared to a cathode with a flat surface. Both the experimental results and the predictions of the GEANT4 model suggests that a 5-counter detector stack with coated grooved cathodes has the same efficiency as a 7-counter stack with flat cathodes. The reduction in the number of counters in the stack without altering the detection efficiency will prove highly beneficial for large-area position-sensitive detectors for neutron scattering applications, for which the cost-effective manufacturing of the detector and associated readout electronics is an important objective. The proposed detector concept could be a technological option for one of the new chopper spectrometers and other instruments planned to be built at the future European Spallation Source in Sweden. These results with macrostructured cathodes generally apply not just to MWPCs but to other gaseous detectors as well.

Experimental Study of a Two-dimensional MWPC

Design and Experimental Study of a Two-Dimensional Position Sensitive X-ray Detector

Developments of a 2D position sensitive neutron detector

Construction of a two-dimensional thermal neutron detector

The Construction of a Two-Dimensional Position Sensitive X-ray Detector

Development of a MWDC Prototype of the CSR External-Target Experiment

Performance Study of the Multi-purpose Time Projection Chamber (MTPC) Using a Four-Component Alpha Source

A 10B-based neutron detector with stacked Multiwire Proportional Counters and macrostructured cathodes

Development of a multi-channel readout electronics verification system for MWDC detectors

Design and test for the CEPC muon subdetector based on extruded scintillator and SiPM

Gap Uniformity Study of a Resistive Micromegas for the Multi-purpose Time Projection Chamber (MTPC) at Back-n White Neutron Source

Development of L-Bent Positron Detectors for Μ SR Applications at China Spallation Neutron Source

The Research and Development of a Prototype Cosmic Ray Muon Tomography Facility with Large Area MRPC Detectors

AWCC Simulations Based on Monte Carlo Code RMC

Development of the double spoke cavity prototype for CSNS-II

Upgrade of Xuanwu: A Dual-Mode Neutron Powder Diffractometer at CMRR

Optimization of detector placements in reduction of multiple counts for mu SR measurements at China Spallation Neutron Source

Measurement of the neutron beam profile of the Back-n white neutron facility at CSNS with a Micromegas detector

The Study of Boron-Lined Honeycomb Neutron Detector with a Multi-Wire Proportional Chamber Readout

Study of the Response of 10B-Doped MCP to Wide-Energy Range Neutrons from Ev to MeV