Abstract:Since the split-Hopkinson pressure bar (SHPB) test technology was proposed, it has played an important role in the study of dynamic mechanical properties of materials under the impact of dynamic load. It is a major test technology for the study of dynamic mechanical properties of materials. The expansion of the range of materials studied has also posed a challenge to the SHPB test technique, requiring some improvements to the conventional SHPB test apparatus and analysis methods to meet the test conditions and ensure the accuracy of its results. Based on a systematic review of the development of the SHPB test technique and the test principles, the main factors that influence the test's ability to meet the two basic assumptions at this stage are analyzed, and the ways to handle them are summarized. The stress wave dispersion phenomenon caused by the transverse inertia effect of the pressure bar means that the test no longer satisfies the one-dimensional stress wave assumption, while the pulse-shaping technique effectively reduces the wave dispersion phenomenon and also has the effect of achieving constant strain rate loading and promoting the dynamic stress equilibrium of the specimen. Impedance matching between the pressure bar and specimen effectively solves the problem of the test's difficulty because the transmitted signal is weak, and the assumption that the stress/strain is uniformly distributed along the length of the specimen is not satisfied when studying low-wave impedance material with the conventional SHPB test device. The appropriate pressure bar material can be selected according to the value of the wave impedance of the test material. According to the wave impedance values of different materials, the corresponding suggestions for the selection of pressure bar materials are given. Moreover, a new pressure bar material (modified gypsum) for materials with very-low-wave impedance is proposed. Finally, for some materials (foamed concrete, aluminum honeycomb, porous titanium, etc.) that cannot meet the two basic assumptions of the test, the Lagrangian analysis method can be combined with SHPB test technology application. Based on the analysis and calculation of the energy conservation equation, the dynamic constitutive relationship of the materials can be obtained without assuming the constitutive relationship of the experimental materials.

On the Errors Associated with the Use of Large Diameter SHPB, Correction for Radially Non-Uniform Distribution of Stress and Particle Velocity in SHPB Testing

Investigation on Experimental Method of Low-Impedance Materials Using Modified Hopkinson Pressure Bar

Design and Calibration of a Large-Scale 155-mm Split-Hopkinson Pressure Bar

Experimental and numerical investigations on the use of polymer Hopkinson pressure bars

A new method for the separation of waves. Application to the SHPB technique for an unlimited duration of measurement

Correction Method and Verification of Radial Inertia and Friction Effects under a Unified Deformation Framework in SHPB Experiments on Soft Materials

Large Dimension Hopkinson Pressure Bar and Its Application

On the Use of A Viscoelastic Split Hopkinson Pressure Bar

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

Correlation between the accuracy of a SHPB test and the stress uniformity based on numerical experiments

Review of SHPB Dynamic Load Impact Test Characteristics and Energy Analysis Methods

On loading ceramic-like materials using split Hopkinson pressure bar

Numerical Simulation of the Rational Loading Waveform in Large Diameter SHPB Dynamic Test for Rock-Like Materials

Strain-rate effect of polymers and correction methodology in a SHPB test

Wave dispersion analysis and simulation method for concrete SHPB test in peridynamics

Some Fundamental Problems Concerning the Measurement Accuracy of the Hopkinson Tension Bar Technique

A theoretical analysis about the influence of interfacial friction in SHPB tests

Numerical Analysis of Dynamic Failure Process of Inhomogeneous Medium Based on Large Diameter Shpb Test

Experimental and Numerical Evaluation of Rock Dynamic Test with Split-Hopkinson Pressure Bar

Material behaviour characterisation using SHPB techniques, tests and simulations

Numerical Simulation of the Rock SHPB Test with a Special Shape Striker Based on the Discrete Element Method