Abstract:The mechanical behavior of MDYB-3(milled-polished directional) aeronautic PMMA(polymethyl methacrylate) was systematically studied in this paper,with the strain rates from 10~(-4)/S to 2×10~3/S,and the temperatures from-55℃ to 120℃.Tests were performed by MTS servohydraulic testing machine and the split Hopkinson bar,for low and high strain-rate tests respectively.For dynamic tensile mechanical properties,the specimens were directly adhered to the ends of incident and transmission bar,so that effective tensile results were obtained. The results show that the modulus and yield stress of MDYB-3 decrease with the increasing of temperatures at low strain rates.When testing temperature reaches to the glass transition point,the modulus and yield stress approach to constant values as the polymer chain segments change from frozen to free.When the strain rate isn't less than 10~2/S,the dynamic compression modulus also approaches to a constant value at low temperatures.But at high temperatures the compression modulus doesn't approach to a constant value.The phenomena of plasticity flow and strain hardening are observed during dynamic tensile tests,whereas these phenomena are not observed during dynamic compression test.Finally,based on the detailed test results and published constitutive relation,a viscoelastic constitutive model is developed.

Dynamic Mechanical Analysis of High Gloss PC/PMMA Composites

Dynamic Mechanical Analysis of Flame Retardant PC/ABS Composites

Viscoelastic Behavior of Poly(Methyl Methacrylate-Co-Methyl Acrylate) Random Copolymer Studied by Dynamic Mechanical Analysis and Nanoindentation

Damping and Adhesion Properties of PMMA/EMA-GMA Blends

Experimental Investigation of the Viscoelastic Deformation of PC, ABS and PC/ABS Alloys

STUDY OF THE DYNAMIC MECHANICAL PROPERTIES OF EPDM／Al(OH)3 COMPOSITES

Study on Dynamic Rheological Properties of Flame Retardant PC/ABS Composites System

Mechanical Behavior of MDYB-3 PMMA at Different Temperatures and Strain Rates

Preparation and Properties Study of PGMA/PMMA

Experimental study on mechanical behaviors of injection molded PC/PMMA blends

Viscoelastic Deformation of Pc/Abs Alloy

Rheological Properties, Morphology, and Thermal Performance of E‐MA‐GMA/PC Blend

The Dynamic Mechanical Properties of EPDM/Al(OH)3 Composites

Investigation of Viscoelastic Deformation and Constitutive Modeling of PC, ABS and PC/ABS Alloys

Rheological, flame retardancy, and thermomechanical properties of polymethyl methacrylate composites: Effects of flame retardant and toughener

Study on Dynamic Rheological Properties of PC/PA6 Blend

Effect of In-Situ Compatibility Interface Strength on the Properties of PA6/PMMA Blends

Preparation and Properties of Scratch Resistance and High Surface Gloss ABS/PMMA Alloy

Studies on Thermomechanical Characteristics of Poly(Methyl Methacrylate) and Ethylene-Methyl Acrylate Copolymer Blends

Fabrication of Permanent Antistatic PMMA Copolymer for Enhanced Antistatic and Mechanical Properties

Influence of Methyl Methacrylate-Co-glycidyl Methacrylate Copolymers on the Compatibility, Morphology and Mechanical Properties of Poly(butylene Terephthalate) and Polycarbonate Blends