Abstract:Accurate measurements of the radon exhalation rate help identify and evaluate radon risk regions in the environment. Among these measurement methods, the closed-loop method is frequently used. However, traditional experiments are insufficient or cannot analyze the radon migration and exhalation patterns at the gas–solid interface in the accumulation chamber. The CFD-based technique was applied to predict the radon concentration distribution in a limited space, allowing radon accumulation and exhalation inside the chamber intuitively and visually. In this study, three radon exhalation rates were defined, and two structural ventilation tubes were designed for the chamber. The consistency of the simulated results with the variation in the radon exhalation rate in a previous experiment or analytical solution was verified. The effects of the vent tube structure and flow rate on the radon uniformity in the chamber; permeability, insertion depth, and flow rate on the radon exhalation rate and the effective diffusion coefficient on back-diffusion were investigated. Based on the results, increasing the insertion depth from 1 to 5 cm decreased the effective decay constant by 19.55%, whereas the curve-fitted radon exhalation rate decreased (lower than the initial value) as the deviation from the initial value increased by approximately 7%. Increasing the effective diffusion coefficient from 2.77 × 10 −7 to 7.77 × 10 −6 m 2 s −1 made the deviation expand from 2.14 to 15.96%. The conclusion is that an increased insertion depth helps reduce leakage in the chamber, subject to notable back-diffusion, and that the closed-loop method is reasonably used for porous media with a low effective diffusion coefficient in view of the back-diffusion effect. The CFD-based simulation is expected to provide guidance for the optimization of the radon exhalation rate measurement method and, thus, the accurate measurement of the radon exhalation rate.

Considerations and Measurements of Radon Exhalation Rate

Accurate Measurement of the Radon Exhalation Rate of Building Materials Using the Closed Chamber Method

Evaluation and measurement methods for the surface radon exhalation rate of buildings

Novel approaches for accurately measuring radon exhalation rate and mechanism interpreted by numerical simulation

China indoor radon levels and control of new measures

INTRODUCTION AND TESTING OF A SIMPLIFIED METHOD FOR THE EVALUATION OF THE RADON EMANATION

Numerical simulations for radon migration and exhalation behavior during measuring radon exhalation rate with closed-loop method

A novel method to simulate radon exhalation rate with a solid Rn-222 source

Evaluation of accurate measurement methods for radon exhalation rate with advection effect and application in field

Reference device for calibration of radon exhalation rate measuring instruments and its performance

Radon and thoron exhalation rate from building materials: experimental evaluations and theoretical models

RADON EXHALATION FROM SOIL AND ITS DEPENDENCE FROM ENVIRONMENTAL PARAMETERS

Radon Exhalation Rate: A Metrological Approach for Radiation Protection

Performance evaluation of radon active sensors and passive dosimeters at low and high radon concentrations

Comparison of Radon Mass Exhalation Rate Measurements from Building Materials by two Different Methods

A model comparison of diffusion-controlled radon exhalation from solid and cavity walls with application to high background radiation areas

AN EXPERIMENTAL CHAMBER FOR TESTING ABATEMENT EFFECTS OF RADON EXPOSURE WITH DIFFERENT MEASURES

Radon exhalation behavior and determination of diffusion migration parameters in spherical porous emanation media

Numerical analysis and modeling of two-loop experimental setup for measurements of radon diffusion rate through building and insulation materials

Activity measurements of radon from construction materials

Determination of radon exhalation rate from different mixture of concrete