Abstract:Accurate measurements of the radon exhalation rate help identify and evaluate radon risk regions in the environment. Among these measurement methods, the closed-loop method is frequently used. However, traditional experiments are insufficient or cannot analyze the radon migration and exhalation patterns at the gas–solid interface in the accumulation chamber. The CFD-based technique was applied to predict the radon concentration distribution in a limited space, allowing radon accumulation and exhalation inside the chamber intuitively and visually. In this study, three radon exhalation rates were defined, and two structural ventilation tubes were designed for the chamber. The consistency of the simulated results with the variation in the radon exhalation rate in a previous experiment or analytical solution was verified. The effects of the vent tube structure and flow rate on the radon uniformity in the chamber; permeability, insertion depth, and flow rate on the radon exhalation rate and the effective diffusion coefficient on back-diffusion were investigated. Based on the results, increasing the insertion depth from 1 to 5 cm decreased the effective decay constant by 19.55%, whereas the curve-fitted radon exhalation rate decreased (lower than the initial value) as the deviation from the initial value increased by approximately 7%. Increasing the effective diffusion coefficient from 2.77 × 10 −7 to 7.77 × 10 −6 m 2 s −1 made the deviation expand from 2.14 to 15.96%. The conclusion is that an increased insertion depth helps reduce leakage in the chamber, subject to notable back-diffusion, and that the closed-loop method is reasonably used for porous media with a low effective diffusion coefficient in view of the back-diffusion effect. The CFD-based simulation is expected to provide guidance for the optimization of the radon exhalation rate measurement method and, thus, the accurate measurement of the radon exhalation rate.

AN EXPERIMENTAL CHAMBER FOR TESTING ABATEMENT EFFECTS OF RADON EXPOSURE WITH DIFFERENT MEASURES

Intercomparison of Commercially Available Active Radon Measurement Devices in a Discovered Radon Chamber

A novel method to simulate radon exhalation rate with a solid Rn-222 source

Accurate Measurement of the Radon Exhalation Rate of Building Materials Using the Closed Chamber Method

Numerical simulations for radon migration and exhalation behavior during measuring radon exhalation rate with closed-loop method

Confined Spaces in Buildings with High Indoor Radon Concentration: A Case Study Analysis with the Application of Constructive Remediation Measures

The Study on Effects of Indoor Air Filtration on Radon Exposure to Residents

Equipment for Testing Measuring Devices at a Low-Level Radon Activity Concentration

Influence of Ventilation on the Reduction of the Radon Concentration in an Underground Research Facility

A study about remedial measures to reduce 222Rn concentration in an experimental building

Field Measurements on Unattached Fraction of Indoor Radon Progeny and Its Dose Evaluation

Considerations and Measurements of Radon Exhalation Rate

The Scale Model Room Approach to Test the Performance of Airtight Membranes to Control Indoor Radon Levels and Radiation Exposure

Field Measurement of the 218 Po, 214 Pb and 214 Bi Concentrations in Typical Indoor and Outdoor Environments in Beijing

Construction and Measurements of an Improved Vacuum-Swing-Adsorption Radon-Mitigation System

Small ion pulse ionization chamber for radon measurement in underground space

Evaluation and measurement methods for the surface radon exhalation rate of buildings

INTRODUCTION AND TESTING OF A SIMPLIFIED METHOD FOR THE EVALUATION OF THE RADON EMANATION

Numerical analysis and modeling of two-loop experimental setup for measurements of radon diffusion rate through building and insulation materials

Behaviours and Influence Factors of Radon Progeny in Three Typical Dwellings

Novel approaches for accurately measuring radon exhalation rate and mechanism interpreted by numerical simulation