Non-woven Fabric Supported Poly(acrylonitrile-Vinyl Acetate) Gel Electrolyte for Lithium Ion Battery Use

Xiaoping Li,Mumin Rao,Youhao Liao,Weishan Li,Mengqing Xu
DOI: https://doi.org/10.1007/s10800-010-0200-0
IF: 2.925
2010-01-01
Journal of Applied Electrochemistry
Abstract:This paper reported on a new gel polymer electrolyte (GPE) based on polyethylene (PE) non-woven fabric supported poly(acrylonitrile-vinyl acetate) (P(AN-VAc)/PE) membrane for lithium ion battery use. The preparation and performances of the P(AN-VAc)/PE membrane and its GPE based on 1 M LiPF6 in dimethyl carbonate/diethylene carbonate/ethylene carbonate (1:1:1 in volume) were investigated with a comparison of the unsupported P(AN-VAc) membrane. It is found that the P(AN-VAc)/PE membrane shows better mechanical strength and pore structure for electrolyte uptake than the P(AN-VAc) membrane, and subsequently the GPE based on P(AN-VAc)/PE exhibits higher ionic conductivity and electrochemical stability on cathode than the GPE based on P(AN-VAc). With the support of the non-woven fabric, the ionic conductivity of the GPE at room temperature increases from 1.4 to 3.8 mS cm−1, the oxidation decomposition potential of the GPE on a stainless steel is improved from 5.0 to 5.6 V (vs. Li/Li+). The mesocarbon microbeads (MCMB)/LiMn2O4 battery using P(AN-VAc)/PE as separator retains 94% of its initial discharge capacity after 100 cycles at C/2 rate, showing that the P(AN-VAc)/PE membrane is a possible alternative to the expensive separator for current liquid lithium ion battery.
What problem does this paper attempt to address?