Abstract:This paper presents a monolithically integrated aptasensor composed of a piezoresistive microcantilever array and an on-chip signal processing circuit. Twelve microcantilevers, each of them embedded with a piezoresistor, form three sensors in a Wheatstone bridge configuration. The on-chip signal processing circuit consists of a multiplexer, a chopper instrumentation amplifier, a low-pass filter, a sigma-delta analog-to-digital converter, and a serial peripheral interface. Both the microcantilever array and the on-chip signal processing circuit were fabricated on the single-crystalline silicon device layer of a silicon-on-insulator (SOI) wafer with partially depleted (PD) CMOS technology followed by three micromachining processes. The integrated microcantilever sensor makes full use of the high gauge factor of single-crystalline silicon to achieve low parasitic, latch-up, and leakage current in the PD-SOI CMOS. A measured deflection sensitivity of 0.98 × 10 − 6 nm −1 and an output voltage fluctuation of less than 1 μV were obtained for the integrated microcantilever. A maximum gain of 134.97 and an input offset current of only 0.623 nA were acquired for the on-chip signal processing circuit. By functionalizing the measurement microcantilevers with a biotin-avidin system method, human IgG, abrin, and staphylococcus enterotoxin B (SEB) were detected at a limit of detection (LOD) of 48 pg/mL. Moreover, multichannel detection of the three integrated microcantilever aptasensors was also verified by detecting SEB. All these experimental results indicate that the design and process of monolithically integrated microcantilevers can meet the requirements of high-sensitivity detection of biomolecules.

Monolithic Integration of Micro-Cantilever and Readout Circuits

Monolithic integration of micromachined sensors and CMOS circuits based on SOI technologies

Monolithic Integration Of Micro-Cantilever With Conditioning Circuits Based On Soi Techniques

Design of High-Sensitivity Cantilever and Its Monolithic Integration with CMOS Circuits

Recent Advances in Monolithic Integration of Diverse Technologies with Si CMOS

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Discussion on the optical-coupling in silicon optical-type micromechanical sensors

IC Simulations of the On-chip Integration for SOI CMOS and MEMS

A Monolithically Integrated Microcantilever Biosensor Based on Partially Depleted SOI CMOS Technology

Monolithic Integration of Multiple Sensors on a Single Silicon Chip

A CMOS Compatible Process for Monolithic Integration of High-Aspect-ratio Bulk Silicon Microstructures

Design and fabrication of a monolithic optoelectronic integrated circuit chip based on CMOS compatible technology

Heterogeneous Integration of MEMS Sensor Array and CMOS Readout IC with Through Silicon Via Interconnects

MEMS monolithic integration technology

Cantilever-Based Biosensors in CMOS Technology

3-D Integration and Through-Silicon Vias in MEMS and Microsensors

Integration of SoC and LOC

Ultra-Sensitive Tactile Force/Proximity Sensor Based on Monolithically Integrated Microcantilever

Integration of Multifocal Microlens Array on Silicon Microcantilever via Femtosecond-Laser-Assisted Etching Technology

Post-CMOS Process for High-Aspect-ratio Monolithically Integrated Single Crystal Silicon Microstructures

Study on Compatible CMOS-MEMS Process with Surface Micromachining for the Application of Monolithic Integration