Effects of powder characteristics and grinding processes on fluidity of ceramic injection moulding mixtures

Z. P. Xie,Y. Huang,J. G. Wu

DOI: https://doi.org/10.1007/BF00423394

1995-01-01

Journal of Materials Science Letters

Abstract:The fluidity of ceramic mixtures for injection moulding, one of the attractive fabrication processes for engineering ceramic components with complex shapes, has attracted considerable attention [1-3]. Many studies [4-6] have shown that the fluidity of the ceramic mixture mainly depends on the powder characteristics of the solids once the organic vehicles for injection moulding are fixed. The volume fraction of solids in the mixture and the green density of the formed bodies are also influenced by the powder characteristics. Mangels [7] studied the relationship between injection fluidity and particle size distributions of silicon powders using different ball mill processes and air classification, and it was found that the wide size distribution obtained by 140 h dry ball milling exhibits better injection fluidity. Honma et al. [8] also studied the effects of particle size and specific surface area of silicon nitride on injection fluidity. However, previous work on injection fluidity seldom dealt with the effects of the surface free energy of the powders, which has a close relationship with surface activity, adhesion and the lubrication behaviour of the surface. Also less studied are the effects of the grinding processes on the ceramic powders. In this paper, the effects of the powder surface characteristics on injection fluidity were investigated, and especially the surface free energy of the silicon nitride powders obtained when using different grinding processes.