Abstract:This work investigates the effects of gas preheating and N2 dilution on soot formation in a series of laminar methane (CH4), ethane (C2H6), and propane (C3H8) co-flow diffusion flames. A modified Santoro-type burner was used to produce the flames with a series of preheat temperatures of both co-flow air and inlet fuels between 293 and 723 K. Planar laser-induced incandescence and line-of-sight beam extinction were employed to quantitatively measure the planar distributions of soot volume fractions, and two-color pyrometry was used to measure the soot temperature. The results show that the soot volume fraction significantly increases with the gas preheat temperature for all flames. A rise in the preheat temperature accelerates soot evolution and leads to the higher percentage of carbon conversion to soot in the flames. This enhancement is more remarkable in the flames of fuel with a lower sooting propensity than those with a high sooting propensity. Both axial and radial soot temperatures in the CH4 and C2H6 flames increase with the gas preheat temperature significantly. However, a reverse changing trend is observed in the central region of C3H8 flames, owing to the greater heat losses resulting from the incomplete combustion and strong soot radiation. Adding N2 to the fuel flow suppresses soot formation via the direct dilution effect on the fuel concentration and the indirect effect of changing the flame temperature. As the gas preheat temperature increases, an increasing proportion of the contribution of the direct dilution effect is observed in the N2-diluted C2H6 flames. In addition, the global activation energy of soot formation for the three fuels is estimated on the basis of the measured soot temperature and soot formation rate in the present work.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c03426?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c03426</a>.Calculated pyrolysis products for (a) CH4, (b) C2H6, (c) N2-diluted (50%) C2H6, (d) C3H8, and (e) N2-diluted (66.7%) C3H8 under different temperatures (Figure S1), relationship between laser fluence and normalized LII signal intensity (Figure S2), vertical laser fluence profile of the laser sheet where the laser fluence was set as approximately 0.3 J/cm2 (Figure S3), and calibrated relationship between soot volume fraction (fv) and LII signal intensity at the height from 15 to 40 mm in the propane flame IV-0, with the solid line representing the fitting curve to the experimental data and the two short dashed lines representing the boundaries of ±15% uncertainty in the fitting correction factor (Figure S4) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c03426/suppl_file/ef0c03426_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Experimental Study on Soot Combustion and Its Noncatalyzed Reaction with No

Effects of Na and Fe on the Formation of Coal-Derived Soot in a Two-Stage Flat-Flame Burner

Performance of soot oxidation by O 2 /NO/N 2 atmosphere in various catalyst species

Coal-Derived Soot Behaviors in O2/N2 and O2/CO2 Atmospheres, Studied Through a 1-D Transient Coal Combustion Model

Experimental Studies on Soot in MILD Oxy-Coal Combustion Flame: Sampling, Microscopic Characteristics, Chemical Compositions and Formation Mechanism

Revealing the boosting role of NO for soot combustion over CeO2(111): A first-principles microkinetic modeling

Experimental study on combustion and NO formation characteristics of semi-coke

Insight into soot formed in coal combustion flame: Evolution of physiochemical structure, oxidation reactivity

Experimental study on NOx emission characteristics under oxy-fuel combustion

Simultaneous Investigation of Coal Ignition and Soot Formation in Two-Stage O2/N2 and O2/CO2 Atmospheres

Promoting Soot Combustion Efficiency by Strengthening the Adsorption of NOx on the 3DOM Mullite Catalyst

Effects of Adsorbed and Gaseous NOx Species on Catalytic Oxidation of Diesel Soot with MnOx–CeO2 Mixed Oxides

Relevance of soot formation characteristics to equivalence ratio and CO2 addition of acetylene flame

Study on Soot Emission Characteristics of Methane/Oxygen Inverse Diffusion Flame

Characteristics of NO emission and combustion during pulverized coal combustion under conditions with low oxygen concentration

Evolution of physicochemical characteristics of soot in a single coal combustion flame

Soot particles analysis in laminar premixed propane/oxygen (C3H8/O2) flames using published measurement data

Diesel soot combustion in air-NO environment: Evolution of functional groups on soot surfaces

Optical Investigations on Particles Evolution and Flame Properties During Pulverized Coal Combustion in O2/N2 and O2/CO2 Conditions

Study on Soot and NOx Formation Characteristics in Ammonia/Ethylene Laminar Co-Flow Diffusion Flame

Effects of the Gas Preheat Temperature and Nitrogen Dilution on Soot Formation in Co-flow Methane, Ethane, and Propane Diffusion Flames