Abstract:In order to investigate how particle aggregation affects tensile mechanical performance of composite, a ductile biopolymer (poly(caprolactone)) was melt-compounded with CaCO3 particles over a wide concentration range from 10 to 60 wt.%. The aggregation of CaCO3 particles in poly(caprolactone) (PCL) is investigated depending on particle concentration and surface modification (with stearic acid (2.5 wt.%)) based on rheological assessment. If the composite is mixed with a high concentration of particles (> 30 wt.%), morphological observations and a thermal behavior analysis do not find a difference in the particle aggregation regardless of particle surface modification. However, the linear viscoelastic moduli of the composites distinguishes the difference in particle aggregation regarding to surface modification, indicating induced aggregation behavior with surface-modified CaCO3 (sCC). The composite with sCC starts to form network structure of particles at a lower concentration (30 wt.%) than that with unmodified particles (40 wt.%). When particles form the network structure above the particle percolation threshold, the yield strength of the composite begins to decrease even though Young's modulus is still increasing. In contrast to the expectation of the better dispersion of particles by surface modification as well as improved tensile mechanical performance with better dispersion, sCC rather induced aggregation with a lower concentration of particle than unmodified particles which resulted in decrease in yielding performance. This study showed that rheological study, especially for the composite with high concentration of particles, is useful to figure out the particle dispersion against a limit at morphology observation.

INFLUENCE OF SURFACE-MODIFICATION FOR CALCIUM CARBONATE ON THE INTERACTION BETWEEN THE FILLERS AND POLYDIMETHYLSILOXANE

Surface Modification of Halloysite/Sericite

Influence of Surface Property of CaCO3 Fillers on Apparent Viscosity of Filled Polydimethylsiloxane

Effect of Surface Modification of Montmorillonite on the Properties of Rigid Polyurethane Foam Composites

Influence of Incorporating CaCO3 into Room Temperature Vulcanized Silicone Sealant on Its Mechanical and Dynamic Rheological Properties

Modification of the Filler based on Kaolin and its Use in the Polymer Composites

Studies on the Steady and Dynamic Rheological Properties of Poly(dimethyl‐siloxane) Filled with Calcium Carbonate Based on Superposition of Its Relative Functions

Modification of Poly(vinyl Chloride) with Nano-CaCO3 Coated with Poly(methyl Methacrylate)

Experimental study of rheological behavior of inorganic filler/PDMS compounding system

Modification of Larger Size CaCO3particle with Polystyrene Viain Situemulsion Polymerisation

Effects of Surface Modification with Stearic Acid on the Dispersion of Some Inorganic Fillers in PE Matrix

Linear/Nonlinear Rheological Properties and Percolation Threshold of Polydimethylsiloxane Filled with Calcium Carbonate

Assessment of efficacy of trivalent lanthanum complex as surface modifier of calcium carbonate

Surface Modification of Colloidal Polymer Particles and Its Effect on Cement Hydration

Characterization of Surface Interaction of Inorganic Fillers with Silane Coupling Agents

Encapsulation of Carboxyl Polymer on the Surface of Nanometer Calcium Carbonate

Change of rheological/mechanical properties of poly(caprolactone)/CaCO3 composite with particle surface modification

Surface Modification of CaCO3 by Ultrasound-Assisted Titanate and Silane Coupling Agents

Surface modification of calcium carbonate: A review of theories, methods and applications

Myristic acid as surface modifier of calcium carbonate hydrophobic nanoparticles

Effect of Surface Modification of CaCO_3 on Mechanical Properties of PP/CaCO_3 Composite