Abstract:Spectroscopy based methods have proven great potential in efficient, non-invasive material characterization. Recording the material-specific optical properties delivers instant information on the composition of an investigated sample surface without chemical sample preparation and may be operated in spatially continuous mode.&#160;In minerals, laser-induced fluorescence (LiF) provides a promising method to address the challenges of robust and efficient rare-earth element (REE) detection.&#160;The method is based on the characteristic electronic transitions within the incompletely filled f-shell of REE. The corresponding emission shows distinct features (spectral fingerprints) in the visible and near-infrared (VNIR) range of the electromagnetic spectrum that allow to distinguish between individual REE and mineral matrix luminescence. Only REE with completely filled or empty f-orbitals miss characteristic luminescence (i.e. Y3+, Sc3+, La3+, Lu3+), while the emissions of Gd3+ lie at lower wavelengths than the observed VNIR range.We test the suitability of LiF in applications of REE identification by (1) building a spectral LiF library from a sample set of luminescent REE phosphates and (2) evaluating observed emissions in samples of non-luminescent REE, and (3) comparing indicated REE cross-contamination to results of neutron activation analysis (NAA). As samples, we use the Smithsonian REE phosphate standards for electron microprobe analysis. The synthetic material delivers a simple, well-defined host composition, is well investigated and NAA results are available on additional trace REE concentration resulting from the material production procedure. The trace REE concentrations are at the order of 10-4 given in mass fraction. We employ laser-induced fluorescence at three commonly used laser wavelengths (325 nm, 442 nm, 532 nm) to acquire our REE sample spectra and record LiF signals in the visible to near-infrared spectral range (350 &#8211; 1080 nm).The comparison of spectra from non-luminescent REE phosphates shows clear similarities in emission patterns that can be assigned to specific luminescent REE using the spectral LiF library. Our results demonstrate the suitability of LIF for REE detection along with the benefits of selective element excitation and highlight the high sensitivity of the LiF method. The detected emissions in the non-luminescent samples indicate a detection limit below mass fractions of 10-4, when compared to NAA results, but also show that not all REE are equally responsive. Here, the co-existence of REE with complex interactions such as charge transfer contributes to the observed emission pattern.&#160;Adding to the spectral LiF library data and expanding investigations to further mineral hosts will facilitate new applications of LIF for REE analysis in natural samples and its implementation in raw material exploration.

Determination of Rare-Earth Elements in a Limestone Geological Standard Reference Material by ICP-MS Following Solvent Extraction

Determination of rare earth elements in ferrocarbonatite using ICP-AES and ICP-MS

Determination Of Trace Rare Earth Elements In Soils By Inductively Coupled Plasma-Mass Spectrometry After Microwave Digestion For Sample Preparation

Multielemental Determination of Rare Earth Elements in Seawater by Inductively Coupled Plasma Mass Spectrometry (ICP-MS) After Matrix Separation and Pre-concentration With Crab Shell Particles

Flow Injection On-Line Solid Phase Extraction Coupled with Inductively Coupled Plasma Mass Spectrometry for Determination of (ultra)trace Rare Earth Elements in Environmental Materials Using Maleic Acid Grafted Polytetrafluoroethylene Fibers As Sorbent

Selection of Internal Standards for Determining Rare-Earth Elements by Microwave Induced Plasma Optical Emission Spectrometry

Determination of 14 trace rare earth impurities in high-purity CeO2 by inductively coupled plasma mass spectrometry with membrane desolvation

Elimination of the Spectral Interference from Polyatomic Ions with Rare Earth Elements in Inductively Coupled Plasma Mass Spectrometry by Combining Algebraic Correction with Chromatographic Separation

Determination of trace rare earth elements in coal fly ash and atmospheric particulates by electrothermal vaporization inductively coupled plasma mass spectrometry with slurry sampling

Accurate determination of ultra-trace rare earth elements by LA-ICP-MS/MS and its application to cassiterite for effective elimination of Gd and Tb false positive anomalies

Tetrafluoroboric Acid Digestion for Accurate Determination of Rare Earth Elements in Coal and Fly Ash by ICP-MS Analysis

Sensitive determination of rare earth elements in liquid samples by spatial confinement assisted surface enhanced laser-induced breakdown spectroscopy

Determination of 14 Trace Rare Earth Impurities in High-Purity Europium Oxide by Inductively Coupled Plasma Mass Spectrometry with Membrane Desolvation

Determination of Ultra-trace Rare Earth Elements in Biological Samples by Inductively Coupled Plasma Mass Spectrometry

Laser-induced fluorescence (LiF) spectroscopy for detecting REE cross-contaminations in the Smithsonian rare-earth element phosphate standards

Simultaneous Determination of 50 Elements in Geological Samples by ICP-MS Combined with ICP-OES

Enhanced ICP-MS detection of 24 elemental impurities in complex, high matrix mineral, medicinal lanthanum carbonates according to ICH Q2 (R2)

Development of Dy, Ho, Er, Tm, and Sc mono-element standard solution certified reference materials (GBW08680-08684)

Combined use of multiple external and internal standards in LA-ICP-MS analysis of bulk geological samples using lithium borate fused glass

Determination of ultra-trace rare earth elements in olivine by laser ablation-sector field-inductively coupled plasma-mass spectrometry

Investigation on pretreatment method for the determination of rare earth elements in polymetallic mineral samples in Pan-Xi region by ICP-MS