Abstract:Spectroscopy based methods have proven great potential in efficient, non-invasive material characterization. Recording the material-specific optical properties delivers instant information on the composition of an investigated sample surface without chemical sample preparation and may be operated in spatially continuous mode.&#160;In minerals, laser-induced fluorescence (LiF) provides a promising method to address the challenges of robust and efficient rare-earth element (REE) detection.&#160;The method is based on the characteristic electronic transitions within the incompletely filled f-shell of REE. The corresponding emission shows distinct features (spectral fingerprints) in the visible and near-infrared (VNIR) range of the electromagnetic spectrum that allow to distinguish between individual REE and mineral matrix luminescence. Only REE with completely filled or empty f-orbitals miss characteristic luminescence (i.e. Y3+, Sc3+, La3+, Lu3+), while the emissions of Gd3+ lie at lower wavelengths than the observed VNIR range.We test the suitability of LiF in applications of REE identification by (1) building a spectral LiF library from a sample set of luminescent REE phosphates and (2) evaluating observed emissions in samples of non-luminescent REE, and (3) comparing indicated REE cross-contamination to results of neutron activation analysis (NAA). As samples, we use the Smithsonian REE phosphate standards for electron microprobe analysis. The synthetic material delivers a simple, well-defined host composition, is well investigated and NAA results are available on additional trace REE concentration resulting from the material production procedure. The trace REE concentrations are at the order of 10-4 given in mass fraction. We employ laser-induced fluorescence at three commonly used laser wavelengths (325 nm, 442 nm, 532 nm) to acquire our REE sample spectra and record LiF signals in the visible to near-infrared spectral range (350 &#8211; 1080 nm).The comparison of spectra from non-luminescent REE phosphates shows clear similarities in emission patterns that can be assigned to specific luminescent REE using the spectral LiF library. Our results demonstrate the suitability of LIF for REE detection along with the benefits of selective element excitation and highlight the high sensitivity of the LiF method. The detected emissions in the non-luminescent samples indicate a detection limit below mass fractions of 10-4, when compared to NAA results, but also show that not all REE are equally responsive. Here, the co-existence of REE with complex interactions such as charge transfer contributes to the observed emission pattern.&#160;Adding to the spectral LiF library data and expanding investigations to further mineral hosts will facilitate new applications of LIF for REE analysis in natural samples and its implementation in raw material exploration.

Selection of Internal Standards for Determining Rare-Earth Elements by Microwave Induced Plasma Optical Emission Spectrometry

Combined use of multiple external and internal standards in LA-ICP-MS analysis of bulk geological samples using lithium borate fused glass

Selection of internal standards in inductively coupled plasma atomic emission spectrometry by principal component analysis

Sensitive determination of rare earth elements in liquid samples by spatial confinement assisted surface enhanced laser-induced breakdown spectroscopy

Elimination of the Spectral Interference from Polyatomic Ions with Rare Earth Elements in Inductively Coupled Plasma Mass Spectrometry by Combining Algebraic Correction with Chromatographic Separation

Analysis of Cerium-Substituted Yttrium Iron Garnets Using Inductively Coupled Plasma Atomic Emission Spectrometry with Preliminary Decomposition in a Microwave System

Determination of 14 Trace Rare Earth Impurities in High-Purity Europium Oxide by Inductively Coupled Plasma Mass Spectrometry with Membrane Desolvation

Inductively coupled plasma optical emission spectroscopic determination of trace rare earth elements in highly refractory gadolinium zirconate (Gd2Zr2O7)

Determination of 14 trace rare earth impurities in high-purity CeO2 by inductively coupled plasma mass spectrometry with membrane desolvation

Development of Dy, Ho, Er, Tm, and Sc mono-element standard solution certified reference materials (GBW08680-08684)

A Reliable Calibration Method for Accurate Determination of Major and Trace Elements in Fluorapatite by LA-ICP-MS Without an Internal Standard

Determination Of Trace Rare Earth Elements In Soils By Inductively Coupled Plasma-Mass Spectrometry After Microwave Digestion For Sample Preparation

Elimination Of The Spectral Interference From Barium Polyatomic Ions On Rare Earth Elements In Inductively Coupled Plasma Mass Spectrometry By Ag50w-X8 Cation Exchange Chromatographic Separation

Laser-induced fluorescence (LiF) spectroscopy for detecting REE cross-contaminations in the Smithsonian rare-earth element phosphate standards

Evaluation of internal standardization for the determination of semivolatile analytes in difficult matrices by simultaneous multielement atomic absorption spectrometry

Determination of Ultra-trace Rare Earth Elements in Biological Samples by Inductively Coupled Plasma Mass Spectrometry

A Non-Matrix-Matched Calibration Method for In Situ Major and Trace Element Analysis of Scheelite by Nanosecond LA-ICP-MS

Preliminary Study for the Determination of Rare Earth Elements Using the ICP-MS Technique

Employing a switching valve to automate external standard calibration in inductively coupled plasma optical emission spectrometry

Simultaneous Determination of 15 Elements in Sedimentary Rock Samples by Inductively Coupled Plasma-Atomic Emission Spectrometry

Determination of Rare Impurities in High-Purity Germanium and Germanium Oxide by Inductively Coupled Plasma Atomic Emission Spectrometry