Abstract:The continuous miniaturization of modern electromechanical systems calls for a comprehensive understanding of the mechanical properties of metallic materials specific to micrometer and sub-micrometer scales. At these scales, the nature of dislocation-mediated plasticity changes radically: sub-micrometer metallic samples exhibit high yield strengths, however accompanied by detrimental intermittent strain fluctuations compromising forming processes and endangering structural stability. In this paper, we studied the effects of plate-like $\theta^\prime$-Al$_2$Cu precipitates on the strength, plastic fluctuations and deformation mechanisms of Al-Cu alloys from micro-pillar compression testing. The plate-like precipitates have diameters commensurate with the external size of the Al-Cu micro-pillars. Our results show that these plate-like precipitates can strengthen the materials and suppress plastic fluctuations efficiently at large sample sizes ($\geq 3 \mu m$). However, the breakdown of the mean-field pinning landscape at smaller scales weakens its taming effect on intermittency. Over an intermediate range of sample sizes allowing the precipitates to cross the entire pillar, an enhanced apparent strain hardening and a sharp decrease of jerkiness are observed, in association with the presence of {100}-slip traces along the coherent $\theta^\prime$-Al$_2$Cu precipitate/$\alpha$-Al matrix interface and precipitate shearing. These complex effects of plate-like precipitates on plasticity are analyzed, experimentally and theoretically, in view of the interferences between external and internal sizes, and the related modifications of the underlying plastic mechanisms.

Study on the Transformation Mechanism of Α 1 Plates in a Cu-Zn-Ai Alloy

General Existence of Ledges on Α1 Plates in Cu-Zn-Al Alloys

Ledge structure of bainites in Cu-Zn-Al alloys

Study of Ledge Structures of Bainites in the Cu-Base 27.1Zn-3.6Al Alloy

Atomistic mechanism of η'-to-η transformation in Al-Zn-Mg-Cu alloys

Precipitation in an Al-Zn-Mg-Cu alloy during isothermal aging: Atomic-scale HAADF-STEM investigation

Scanning tunnelling microscopy and transmission electron microscopy study of ultrafine structure and surface relief of bainite in a Cu–Zn–Al alloy

On the shear strain associated with T 1 precipitation in Al-Cu-Li(-Mg-Ag) alloys

Growth kinetics and high-temperature tem in situ observation of bainite in a Cu-Zn alloy

The growth mechanisms of θ′ precipitate phase in an Al-Cu alloy during aging treatment

Phase Transformation in Al/Zn Multilayers during Mechanical Alloying

Low Temperature Phase Transformations in Copper-Quenched Ti-44.5Al-8Nb-2.5V Alloy.

Nucleation and evolution mechanism of precipitates during the initial aging stage in Al-Zn-Mg-Cu alloy

GENERAL EXISTENCE OF LEDGES OF INITIAL BAINITES IN Cu-Zn-Al ALLOYS

Influence of microstructural and crystallographic inhomogeneity on tensile anisotropy in thick-section Al-Li-Cu-Mg plates

Evolution of Deformation Substructure and MgxZnyCaz Metastable Phase in Fine-Grained Mg Alloys

Phase transformation from phase to S phase at grain boundary during annealing in rapidly-solidified Al-Zn-Mg-Cu alloy

Microstructural Evolution and Mechanical Properties of Cast Al-3li-1.5cu-0.2zr Alloy During Heat Treatment

Plate-like Precipitate Effects on Plasticity of Al-Cu Alloys at Micrometer to Sub-Micrometer Scales

Plate-like precipitate effects on plasticity of Al-Cu alloys at micrometer to submicrometer scales

Microstructure and Phase Transformation of Ni46Mn33Ga17Cu4−xZrx Alloys