Abstract:The subunits constituting a bainitic sheaf in an Fe-C-Cr-Si alloy were discovered by scanning tunneling microscopy (STM) to consist of sub-subunits, and sub-subunits were also composed of sub-sub-subunits. Detailed investigation shows that a bainitic relief is composed of many smaller reliefs, which correspond to a different structure of bainite,i.e., subunits, sub-subunits, and sub-sub-subunits. It is determined by STM that the surface relief arising from the formation of bainite in an Fe-C-Cr alloy istent shaped rather than an invariant plane strain (IPS) type of surface relief. Careful observation shows that the relief obtained from a sub-sub-subunit is also tent shaped. It is discovered by STM that an α1 plate,i.e., bainite formed in Cu-Zn-Al alloys, is composed of subunits. This is also demonstrated by transmission electron microscopy (TEM). The preceding results indicate that bainitic plates in Cu-Zn-Al alloys and bainitic subunits in steels are not the smallest structural units. Based on the preceding results on the ultrafine structure and the nature of surface relief accompanying bainite, it is proposed that the bainitic structure forms through a sympathetic nucleation and ledgewise growth (SNLG) mechanism. This article shows that the SNLG mechanism can be successfully applied to interpret the complicated structure of bainite.

Scanning tunnelling microscopy and transmission electron microscopy study of ultrafine structure and surface relief of bainite in a Cu–Zn–Al alloy

Formation of Bainite in Ferrous and Nonferrous Alloys Through Sympathetic Nucleation and Ledgewise Growth Mechanism

Study of Ledge Structures of Bainites in the Cu-Base 27.1Zn-3.6Al Alloy

Stm Study on Surface Relief, Ultra-Fine Structure and Transformation Mechanism of Bainite in Steels

Study on the formation mechanism of bainite

Ledge structure of bainites in Cu-Zn-Al alloys

Surface Relief Associated with Martensite and Bainite in a Cu–Zn–Al Alloy Measured by Atomic Force Microscopy

GENERAL EXISTENCE OF LEDGES OF INITIAL BAINITES IN Cu-Zn-Al ALLOYS

Growth kinetics and high-temperature tem in situ observation of bainite in a Cu-Zn alloy

THE FINE STRUCTURE OF THE BAINITE/MARTENSITE DUAL PHASE STEEL

The Mechanism of Bainite Transformation

FINE STRUCTURE AND CRYSTALLOGRAPHY OF ISOTHERMAL LOWER BAINITE IN AN EXPERIMENTAL STEEL 38Si2mn2mo

Research on bainite transformation in steels

Studies on pre-bainitic transformation in CuZnAlMn alloy

ATOMIC FORCE MICROSCOPE INVESTIGATION OF THE SURFACE RELIEF EFFECT OF BAINITE IN AN Fe-C-Mn-Ni-Si ALLOY

Three-dimensional morphology and crystallographic characteristics of the low-temperature bainitic microstructure in high-carbon steel

The pre-bainitic transformation in CuZnAlMn alloy

Study on the Transformation Mechanism of Α 1 Plates in a Cu-Zn-Ai Alloy

Observation of Bainite Surface Reliefs in Fe–C Alloy by Atomic Force Microscopy

High-Resolution Characterization of Subunits in Nanostructured Bainite in High-Carbon Silicon Steel

Scanning-Tunneling-Microscopy Investigation of Bainite in Steel