Abstract:In response to the problem of significant post-construction settlement that may occur in a motor racing circuit (MRC), two representative composite foundation testing areas, PHC pile (pre-tensioned spun high-strength concrete pile) and CFG pile (cement fly ash gravel pile), were selected for field tests to obtain the deformation law of pile–soil. Then, finite element numerical simulation was used to carry out back analysis on the geological mechanical parameters of the testing areas. The results showed that the error of soil settlement between the piles in the PHC pile and CFG pile testing areas were 8.2% and 9.6%, respectively, with good inversion precision. The obtained geological mechanical parameters can be used to predict the settlement of the rest of the MRC. On this basis, a finite element numerical model was constructed to analyze the bearing and deformation characteristics of the foundation of the MRC under five types of working conditions that may cause significant post-construction settlement. It showed that the settlement of the embankment was large in the middle and small on both sides after the consolidation of the embankment. The maximum settlement was about 27.0 mm, and the maximum longitudinal uneven settlement ratio of the embankment was 1.3/4000. The axial force of piles in the PHC pile and CFG pile composite foundations increased first and then decreased with depth. The maximum bending moment was located at the foot of slopes or at the boundary of strata, which was relatively small in the middle of the embankment. The deformation of the embankment and the bearing capacity of the piles could meet engineering requirements. This study has certain guiding significance for the design and construction of similar pile-net composite foundations.

Numerical Analysis on Bearing Performance of Cast-in-place X-section Pile Composite Foundation under Road Embankment

Performance analysis of cast-in-place tubular pile composite ground under embankment load

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

STUDY ON SINGLE RIGID PILE GROUND IMPROVEMENT MODEL UNDER EMBANKMENT

Analysis of cast-in-situ tubular piles in soft foundation improvement at bridge approaches

In-situ test of bearing capacity behavior of composite foundation with rigid-flexible piles

Characteristic study on composite foundation with rigid-flexible piles under the load from embankment

Numerical Study of the Effect of Material Modulus Upon Cement-Soil Pile Composite Foundation

Numerical analysis on the performance of a cushioned foundation with a mixture of both rigid and flexible piles

Field Study of Bearing Behavior of Pile-Net Composite Foundation

FIELD SURVEY OF COMPOSITE FOUNDATION WITH RIGID PILES UNDER EMBANKMENT

Model Test And Numerical Analysis Of Geogrid-Reinforced Pile-Supported Foundation

A test on base bearing capacity of static drill rooted nodular pile

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Field Tests and the Numerical Analysis of a Pile-Net Composite Foundation for an Intelligent Connected Motor-Racing Circuit

Field Test Study on the Improvement Mechanism of Pile-Net Composite Foundation

Engineering Characteristics Of Composite Foundation With Rigid-Flexible And Long-Short Piles

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

RESEARCH ON INFLUENCE OF SOIL CORE ON BEARING CHARACTER OF LARGE-DIAMETER TUBULAR PILE USING CAST-IN-SITU CONCRETE