Compressive strength of internal curing concrete with lightweight fine aggregate-experiment and modeling

XIANG Ya-ping,WEI Ya,ZHANG Qian-qian,WANG Dong-min

DOI: https://doi.org/10.3969/j.issn.1002-3550.2013.03.012

2013-01-01

Abstract:Two types of saturated lightweight fine aggregates(blast furnace slag and shale sand)were used to substitute the equivalent volume of regular fine aggregates in the concrete specimens(with W/C ratio of 0.3 and 0.4).The influence on 28 d compressive strength due to the replacement of regular fine aggregates by these lightweight fine aggregates was investigated.Experimental evidence showed that when there was 0~60% volume of fine aggregate replaced,at 0.3 W/C ratio,the concrete samples with lightweight fine aggregates would exhibit higher 28 d compressive strength than normal concrete.When 0~40% of fine aggregate was substituted by lightweight fine aggregates,for W/C=0.4,the specimens' 28 d compressive strength decreases as the proportion of fine aggregate increases.When the volume fraction of the replacement fine aggregate and the W/C were equal,the blast-furnace-slag-blend concrete specimens were stronger in compressive than their shale counterparts.It attempted to model the compressive strength of lightweight-fine-aggregate concrete.A parameterlightweight fine aggregate volume-to-porosity conversion coefficient γ(0-1)was introduced.The Strength-porosity relationship,Powers model,internal curing paste volume model were incorporated in this model prediction of the 28 d compressive strength of the specimens.The test results and the model predictions have shown good agreement.