Abstract:The influence of different wind speeds and sealed curing time on early-age shrinkage of cement paste was investigated. The 72-h early-age total shrinkage of cement paste after sealed curing for 0 h, 3 h, 6 h, 9 h, 12 h, and 24 h starting from the initial setting time under different wind speeds was studied. Water loss, autogenous shrinkage, tensile strength, pore size distribution (PSD) and hydration degree were measured. Elastic modulus, cracking strain, and radius of the pores where the meniscus forms were calculated based on the data obtained. For mixtures that did not undergo sealed curing, the wind speed could considerably increase the drying shrinkage and total shrinkage of the cement paste. The wind speed also reduced the early tensile strength, hydration degree, and elastic modulus of the cement paste. Within 1 day, the cracking strain was reduced by wind speed. According to the experimental data, a fitting formula for the early total shrinkage of cement paste is proposed, and the wind speed influencing factor beta(w) is also proposed for the first time. Considering the PSD and water loss to study the mechanism of early drying shrinkage of cement paste, we found that there is a good correlation between r(s) and drying shrinkage. The exponential formula is given between r(s) and drying shrinkage. For mixtures with sealed curing, the total shrinkage and water loss decreased with increasing sealed curing time. However, the effects of water loss at different stages on drying shrinkage were different. Water evaporation in the early stage led to more drying shrinkage than water evaporation in the later stage. Sealed curing also weakened the increasing effect of wind speed on total shrinkage, so that at the same wind speed, the shrinkage increment was considerably reduced. After analysis and comparison, it was found that it is economical and reasonable to adopt sealed curing for 6 or 9 h, which can effectively decrease the early total shrinkage and improve the cracking strain of the cement paste in the wind environment. (C) 2020 Elsevier Ltd. All rights reserved.

Influence of Pre-wetted Lightweight Aggregate on Early-age Shrinkage of High Strength Concrete

Influence of Mineral Admixtures on early Shrinkage of Ordinary Concrete

Influence of Sand Rate on Structural Concrete of Haydite Lightweight Aggregate

Effect of Different Wind Speeds and Sealed Curing Time on Early-Age Shrinkage of Cement Paste

Integrative Study on the Effect of Internal Curing on Autogenous and Drying Shrinkage of High-Strength Concrete

Shrinkage of High-Strength Calcium Sulfoaluminate Cement Concrete with Impact of Pre-Soaked Lightweight Aggregate Internal Curing

Identification of Indexes That Could Reflect Early Drying Shrinkage of High Strength Concrete with Minerals

Powder Gradation Effect on the Fresh, Mechanical, and Early-Age Shrinkage Properties of UHPC

Integrated Shrinkage, Relative Humidity, Strength Development, and Cracking Potential of Internally Cured Concrete Exposed to Different Drying Conditions

Combination Effects of Internal Curing and Permanent Formwork on Shrinkage of High Strength Concrete

Influence of Pre-soaked Light-Weight Aggregate on Early-Age Interior Humidity Distribution and Development in Concrete Slab

Experimental study on shrinkage reduction of calcium sulphoaluminate cement concrete with addition of pre-wetted lightweight aggregate

Evaluation of Shrinkage Induced Cracking in Concrete with Impact of Internal Curing and Water to Cement Ratio

Influence of Early-age Curing Time on Shrinkage of Concrete

Influence of Superplasticizer and Shrinkage-Reducing Admixtures on Early Age Shrinkage of Concrete

Internal Curing Efficiency of Prewetted LWFAs on Concrete Humidity and Autogenous Shrinkage Development

Early-age mesoscale deformation in lightweight aggregate concrete under different water-to-cement ratios and pretreated methods

Research on shrinkage control technology of lightweight ultra-high performance concrete

Research on the Water Absorption and Release Characteristics of a Carbonized γ-C2S Lightweight Aggregate in Lightweight and High-Strength Concrete

Influence Mechanism of Curing Regimes on Interfacial Transition Zone of Lightweight Ultra-High Performance Concrete

Influence of curing conditions on properties of Normal and high strength concrete with and without pre-wetted lightweight aggregates