Abstract:The development of a radial-inlet structure cyclone separator is reported in this paper, which is used as a primary device for gas-particle separation in an opposed multi-burner (OMB) gasification system. The radial-inlet cyclone is more suitable for a high-pressure industrial operation environment on the premise of higher efficiency. A model based on computational fluid dynamics (CFD) techniques was applied to study the performance of a new-type cyclone separator In the approach, the turbulent flow was described by the Reynolds stress model, and the particle flow was described by the stochastic Lagrangian model. The validity of the proposed approach is verified by the good agreement between the measured and the predicted results. The results indicate that, though the velocity flow field is not geometry symmetrical and a three-dimensional unsteady state, it is quasi-periodic. Additionally, there exists a processing vortex core phenomenon in the cyclone. The particle concentration distribution is nonuniform because of the centrifugal force The distribution area can be divided into three parts according to the particles' motion feature And the larger particles are easier to separate than the smaller ones. But particles with a size exceeding a critical value will not be collected at the bottom and stagnate on the conical wall of the cyclone. This will lead to serious erosion on the conical part in the cyclone. In addition, the separation efficiency increases with the particle size, and the cut-point diameter of the radial-inlet cyclone is smaller than the traditional cyclone under the same inlet conditions.

Study on structural optimization of cyclone separator with downward exhaust gas

Analysis of Flow Field and Improved Design of Cyclone Separator with Downward Exhaust Gas

NUMERICAL SIMULATION AND OPTIMIZATION OF GAS-SOLID TWO-PHASE FLOW IN ONE CFBC CYCLONE SEPARATOR

Numerical Simulation of the Flow Field and Performance of an Innovative Cyclone Separator with a Downward Discharge of Gases

Numerical simulation on structure optimization of escape-pipe of cyclone separator with downward outlet

Experimental Investigation of the Separating Characteristics of a Cyclone Separator for a W Shaped Flame-based Boiler

Numerical study of gas-solid flow in a radial-inlet structure cyclone separator

Experimental Study on Gas-Solid Flow Characteristics in Inlet Flue Duct of Cyclone Separator of CFB Boilers

Research on Gas-solid Two-Phase Flow in One CFBC Cyclone Separator

Influence of Edge-sloped Bottom Contraction of Cyclone Separator's Vent-pipe on the Latter's Performance in Circulating Fluidized Bed Boilers

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

Experimental study on the gas-solid two-phase flow in a square cyclone separator with downward gas exit by particle dynamic analyzer

Influence of Inlet Structure on Separation Efficiency of Cyclone Separators

Effect of Exhaust Pipe Size on Separation Efficiency of Cyclone Separator Used in Power Plant

Numerical analysis of a novel cascading gas-liquid cyclone separator

Study of the performance and flow field of a new spiral-roof cyclone separator

Numerical investigation of separation efficiency of the cyclone with supercritical fluid–solid flow

Experimental investigation on separation characteristics of axial cyclone separator

The Numerical Simulation of Calculating Grade Efficiency for Cyclone Separator of CFB boiler

Investigation on separation performance and structural optimization of a two-stage series cyclone using CPFD and RSM

Multi-objective optimization of axial-flow-type gas-particle cyclone separator using response surface methodology and computational fluid dynamics