Abstract:The F317 fault, as a major tectonic zone in the Jianshan mine area, influences the geotectonic features and geomechanical properties of the mine area. Mining operations need to be conducted within these tectonic systems, so it is important to fully study and understand the characteristics and evolution of these tectonic systems to develop reasonable mining plans and safety measures. Aiming at the problem that the existence of the F317 fault affects the stability of the west road during the mining of the security pillar at The Jianshan underground mine in Panzhihua Iron Mine, the mechanical model of the fault surface was established through the theory of material mechanics. The mechanical criterion of fault slip during the security pillar retrieval process was obtained and combined with the contact surface theory in the numerical analysis software FLAC3D. Two numerical calculation models with and without the F317 fault were established to analyze the change characteristics of the maximum tensile stress and displacement of the road protection zone under different simulation scenarios. The influence of the fault’s presence on the surface road’s stability during the security pillar retrieval process was obtained. The study results show that changes in positive and shear stresses at the fault face caused by the security pillar retrieval process are the main factors influencing the fault slip. The upper side of the fault tends to slip along the fault face during the security pillar retrieval process, which theoretically prevents the transfer of subsidence displacement caused by underground mining to the roadside (foot side of the fault). The presence of the F317 fault has less effect on the tensile stresses at the road protection zone. Still, the fault allows the tensile stresses to be concentrated at the top and bottom of the quarry and at the isolated pillar, which is more likely to cause the rock to be stretched and squeezed. Without the F317 fault, the maximum subsidence displacement at the road protection zone is 30.59 mm, the maximum X-directional displacement is 42.17 mm (both of which are greater than the safe displacement limit by 20 mm), and the maximum Y-directional displacement is 19.75 mm, which is less than the safe displacement limit by 20 mm. Compared with the case without the F317 fault, the displacement at the road protection zone with the F317 fault is smaller, with a maximum subsidence displacement of 16.92 mm, a maximum X-directional displacement of 19.63 mm, and a maximum Y-directional displacement of 3.35 mm, all of which are less than the safe displacement limits. Therefore, the presence of the F317 fault provides some protection to the west side of the road from collapse due to underground mining.

Numerical Simulation of Surface Deformation Law Induced by Safety Pillar Stoping

Numerical simulation of the effect of fault inclination on the sudden water of the fault bottom plate

Numerical Simulation Study on The Effect of Isolated Coal Pillar Width on The Subsidence Law of Deep Mining

Numerical Simulation of Stone Column Replacement by Consecutive Dynamic Compaction in Soft Ground

Numerical analysis of surface settlement induced by shield tunnel construction of adjacent structure

Numerical Simulation of Deformation and Fracture Laws for Soft Rock Roadway in Deep Shaft Large Section

Research on Safety Pillar against Water in No.2137 West Lower Working Face, Zhaogezhuang Coalmine, Kailuan

Three Dimensional Finite Element Analysis of Parameters of Boundary Crown Pillar in Transition from Open-pit to Underground Mining

Numerical Simulation of Surface Subsidence and Backfill Material Movement Induced by Underground Mining

Numerical and theoretical analysis of multi-pillar instability under elastic beams

Numerical Simulation on the Structural Parameter Optimization of Ore Block for Non-pillar Continuous Mining

Analysis of Deformation Law of Mining Landslide in Loess Gully Area

High Steep Rock Slope Instability Mechanism Induced by the Pillar Deterioration in the Mountain Mining Area

Numerical Simulation Modeling and Calculation Analysis on Stope Roof Stability under the Complex Geological Conditions in Deep Mining

Numerical analysis of excavation stability of transfer station of Jinan Metro

Surface Movement and Deformation Effect of South Mine and Mining Safety Analysis of the Security Pillar

Rational size and stability analysis of horizontal isolated pillars in deep mining from caving to filling method

Coal pillar safety and surface deformation characteristics of wide strip pillar mining in deep mine

Numerical Simulation of Underground Mining-Induced Fault-Influenced Rock Movement and Its Application

Numerical simulation of mechanical behavior of diaphragm wall during construction

Chamber roof deformation prediction and analysis of underground mining using experimental design methodologies