Controlling plasma-based surface modifications of an austenitic alloy by thermochemical and athermal diffusions
Rafael Fillus Chuproski,Willian Rafael de Oliveira,Bruna C.E. Schibicheski Kurelo,Dair Gabriel Ditzel,Paulo Soares,Francisco Carlos Serbena,Gelson Biscaia de Souza
DOI: https://doi.org/10.1016/j.jallcom.2024.173634
IF: 6.2
2024-01-25
Journal of Alloys and Compounds
Abstract:Under nitrogen plasma immersion ion implantation, the energy density per pulse E Pulse /A was found to be proportional to the amount of the N-expanded austenite phase (γ N ) in a superaustenitic stainless steel, as previously seen for an austenitic-ferritic alloy. Since γ N occurs in a range of stoichiometries, the parameter was also contrasted with the ion fluence Γ, which affects the retained dose. Γ varies inversely with E Pulse /A and influences oppositely the properties of the modified surfaces. The temperature was the same among the treatments (320 °C) to rule out thermal diffusion as an extra variable. The increase of E Pulse /A (for applied voltages 6.2-10.4 kV) produces thicker layers (1.4-2.2 μm), as an increase in lattice defects and stresses enhances N-diffusion, while high Γ values favor the N-saturation at the top surface for the opposite reason. The lowest E pulse /A (6.2-9.5 kV) result in brittle cases with a possible thin nitrides layer on top, whereas γ N prevails in the ductile layer produced by the highest one (10.4 kV). The N-concentration governs the strength against plastic deformation: hardness varies up to 32% from the highest (6.2 kV) to the lowest Γ treatment (10.4 kV). In summary, the correlation of E pulse /A with Γ is indispensable for controlling properties of the modified surfaces for performance purposes.
materials science, multidisciplinary,chemistry, physical,metallurgy & metallurgical engineering